トラバース研削機構の研究(第4報) : 形状生成過程の解析

概要

論文の詳細を見る
In traverse grinding the grinding system stiffness obtained from the stiffness of the center on the tailstock and the workpiece has changed by relative position of the wheel and the workpiece. Further the 'value of wheel wear increases as the grinding process advances. The fact as described above makes quite complicated process of shape generation in traverse grinding. This report analyzes the shape generation process in the direction of work spindle. First the formulation of the grinding system stiffness was conducted and the simulation analysis method of the traverse grinding was established. Used this method the shape generation process can be predicted quantitatively. Next the shape error was defined and the effects of grinding condition parameters on the shape error were considered.
公益社団法人精密工学会の論文
1983-04-05