On the Study of Metal Spinning
スポンサーリンク
概要
著者
-
MUROTA Tadao
Tokyo Institute of Technology
-
Hayama Masujiro
Department Of Industrial Metallurgy Faculty Of Engineering Yokohama National University
-
Hayama Masujiro
Department Of Metallurgy Faculty Of Engineering Yokohama National University
-
Murota Tadao
Tokyo Institute Of Technology Department Of Mechanical Engineering
-
Hayama M.
Department of Metallurgy, Faculty of Engineering, Yokohama National University
関連論文
- Elastic, Plastic Behavior of Rotor : Part 1,Analysis of Axi-Symmetric Rotor Whose Radius Varies in Axial Direction
- On the Non-Uniform Deformation of Material in Axially Symmetric Compression Caused by Friction : Part 3, Theoretical Analysis of Compression of Hollow Cylinder by Finite Element Method
- Improvement of Method of Measuring Strain Using Interference Fringes of Diffracted Beams at Gratings on Specimens : Some Discussions on Multiplication Method
- Analysis of Axi-Symmetric Extrusion
- Theoretical Study of Shear Spinning
- On Compensation of Errors in the Moire Method by Use of Diffraction Beams
- On Interferometry for Measurement of Shear Strain and Rotation by Using Diffraction Beams
- On Interferometry for Measurement of Difference between Two Deformations Using Diffraction Beams
- On Measurement of Three Dimensional Deformation Using Moire Method and Light Slicing Method
- Improvement of the Energy Method Using Finite Element Division and Application to Flat-rolling
- Deformation Modes and Wrinkling of Flange on Shear Spinning
- Experimental Study of Shear Spinning
- Research on the High Speed Bending of Beams with a Punch
- The Fracture of Walls on Shear Spinning : Study on the Spinnability of Aluminium Plates
- On the Non-Uniform Deformation of Material in Axially Symmetric Compression Caused by Friction : Part 4,Experiments Concerning Compression of Hollow Cylinder
- Fundamental Research on the Cold-Roll Forming of Metal Strips
- Finite Element Method in the Analysis of the Hydrostatic Bulging of a Sheet Metal (Part 2)
- Finite Element Method of Analysis of the Hydrostatic Bulging of a Sheet Metal (Part 1)
- Improvement of the Method of Measuring In-plane, Normal Strain Using Interferometry of Diffraction Beams
- Estimation of Torque in Cold Forming of Internal Thread
- Study on Spinnability of Aluminum and It's Alloys
- On the Cold Rolling of Fin of the Air Cooling Pipe
- On the Strength of Cylindrical Shell and Multilayer Vessel under Impact Pressure Loading
- On the Study of Metal Spinning
- Analysis of Working Force in Shear Spinning of Cones
- Theoretical Analysis on Ring Rolling of Plain Ring
- Calculation for Thread Rolling Pressure
- Estimation of Load and Contact width in Rotational Compression of Rod
- Study of Lubrication in Shear Spinning
- Theoretical Method for Estimation of Forces and Torque on Cross Rolling of Stepped Shaft
- Theoretical Study of Tube Spinning