Fundamental Research on the Cold-Roll Forming of Metal Strips
スポンサーリンク
概要
- 論文の詳細を見る
The experimental and the theoretical researchs were performed on the cold-roll forming of metal strips to the cross section of circular arc through a set of the upper roll and the lower. From the experiment, it was found that the membraneous strain in the strip was negligibly small as compared with the bending strain. Therefore, the cold-roll forming was treated as a biaxial bending problem. The roll force and torque were analyzed by means of the strain energy method. The theoretical results were in good agreement with the experimental results.
- 一般社団法人日本機械学会の論文
著者
-
MASUDA Moriji
Tokyo Institute of Technology
-
MUROTA Tadao
Tokyo Institute of Technology
-
JIMMA Takashi
Tokyo Institute of Technology
-
TAMANO Toshitaka
Fuji Iron and Steel Co., Ltd.
-
AMAGAI Toshiyuki
Toyo Rayon Co., Ltd.
-
Tamano Toshitaka
Fuji Iron And Steel Co. Ltd.
-
Amagai Toshiyuki
Toyo Rayon Co. Ltd.
関連論文
- Research on the Shaving Mechanism of Sheet Metals with Punch and Die
- Elastic, Plastic Behavior of Rotor : Part 1,Analysis of Axi-Symmetric Rotor Whose Radius Varies in Axial Direction
- On the Non-Uniform Deformation of Material in Axially Symmetric Compression Caused by Friction : Part 3, Theoretical Analysis of Compression of Hollow Cylinder by Finite Element Method
- Improvement of Method of Measuring Strain Using Interference Fringes of Diffracted Beams at Gratings on Specimens : Some Discussions on Multiplication Method
- Analysis of Axi-Symmetric Extrusion
- Improvement of Moire and Grid Methods of Plastic Strain Analysis and Their Application to Extrusion
- On Compensation of Errors in the Moire Method by Use of Diffraction Beams
- On Interferometry for Measurement of Shear Strain and Rotation by Using Diffraction Beams
- On Interferometry for Measurement of Difference between Two Deformations Using Diffraction Beams
- On Measurement of Three Dimensional Deformation Using Moire Method and Light Slicing Method
- Improvement of the Energy Method Using Finite Element Division and Application to Flat-rolling
- Extension of the Hodograph Method for the One-Dimensional Elastic-Plastic Wave Propagation
- Research on the High Speed Bending of Beams with a Punch
- On the Non-Uniform Deformation of Material in Axially Symmetric Compression Caused by Friction : Part 4,Experiments Concerning Compression of Hollow Cylinder
- Fundamental Research on the Cold-Roll Forming of Metal Strips
- Finite Element Method in the Analysis of the Hydrostatic Bulging of a Sheet Metal (Part 2)
- Finite Element Method of Analysis of the Hydrostatic Bulging of a Sheet Metal (Part 1)
- Improvement of the Method of Measuring In-plane, Normal Strain Using Interferometry of Diffraction Beams
- On the Study of Metal Spinning