The effect of initial parameters on particle size distribution inverted using the laser diffraction technique and a non-linear iterative method
スポンサーリンク
概要
- 論文の詳細を見る
- 2012-09-01
著者
-
Yoshida Hideto
Department Of Chemical Engineering Graduate School Of Engineering Hiroshima University
-
Igushi Tatsuo
Horiba Ltd.
-
IGUSHI Tatsuo
Horiba, Co., Ltd.
関連論文
- Effect of Inlet Duct Shape on Particle Separation Performance of Cyclone Separator
- Particle size measurement of standard reference particle candidates and theoretical estimation of uncertainty region
- Enhancement of the Classification Performance of Electrical Field-Flow Fractionation Using Horizontal Electrophoresis
- Influence of inlet flow rate, pH, and beads mill operating condition on separation performance of sub-micron particles by electrical hydrocyclone
- Rapid and simultaneous determination of multi-element abundances and U-Pb age for zircon crystal using UV laser ablation ICP-MS technique: critical evaluation of the technique with 91500 zircon standard
- Particle size measurement of standard reference particle candidates with improved size measurement devices
- Effects of initial slurry concentration distribution on the particle size distribution measured with a sedimentation balance method
- Synthesis of indium tin oxide powder by solid-phase reaction with microwave heating
- Continuous fine particle classification by water elutriator with applied electro-potential
- Utilization of NaCl for phillipsite synthesis from fly ash by hydrothermal treatment with microwave heating
- Classification of Particles Dispersed by Bead Milling Using Electrical Field-Flow Fractionation
- Effect of Multi-Inlet Flow on Particle Classification Performance of Hydro-Cyclones and New Estimating Equation
- Effects of microwave irradiation on the crystalline phase of zeolite synthesized from fly ash by hydrothermal treatment
- Investigation about Data Reduction and Sedimentation Distance of Sedimentation Balance Method
- Phillipsite synthesis from fly ash prepared by hydrothermal treatment with microwave heating
- Effect of apex cone height on particle classification performance of a cyclone separator
- Particle size measurement with an improved sedimentation balance method and microscopic method together with computer simulation of necessary sample size
- Particle Separation with a Hydro-Cyclone Separator in a Wet Limestone Gypsum FGD Process
- Separation of Unburned Carbon in Fly Ash Particles Using Special Louver Separator
- Classification of Particles Dispersed by Bead Milling Using Electrical Field-Flow Fractionation
- Meteor Storm Activity and Average Size of Meteoroids for the 2001 Leonids by FM Broadcasting Radio Observation
- Effect of Blade Angle on Crystallinity Change in a Mechanical Impact Mill
- Comparison of separation performance between single and two inlets hydrocyclones
- Theoretical calculation of fundamental uncertainty region based on the maximum and/or the minimum size in the preparation of standard reference particles for particle size measurement
- Enhancement of the Classification Performance of Electrical Field-Flow Fractionation Using Horizontal Electrophoresis
- Classification of particles by centrifugal separator and analysis of the fluid behavior
- Environmental Transmission Electron Microscopy Observations of Swinging and Rotational Growth of Carbon Nanotubes
- Separation of Unburned Carbon in Fly Ash Particles Using Special Louver Separator
- Carbon Beads on Semiconductor Nanowires
- Size classification of submicron powder by air cyclone and three-dimensional analysis.
- The effect of initial parameters on particle size distribution inverted using the laser diffraction technique and a non-linear iterative method
- Theoretical calculation of uncertainty region based on the general size distribution in the preparation of standard reference particles for particle size measurement