Particle Separation with a Hydro-Cyclone Separator in a Wet Limestone Gypsum FGD Process
スポンサーリンク
概要
- 論文の詳細を見る
A hydro-cyclone was applied to the separation of gypsum, a byproduct of the wet limestone gypsum flue gas desulfurization (FGD) process, that uses limestone as the raw material. Using a high slurry concentration, similar to that used in an actual plant, the effect of the inlet shape and ceiling clearance of the hydro-cyclone was examined, and a model for predicting the efficiency of separation is proposed.The results indicate that the 50% cut size decreases when the inlet width ratio is decreased. Over the entire range of inlet width ratio, the limestone content of the blow-down flow decreased by approximately half, compared with that of the feed, and it was confirmed the purity of the gypsum could be improved by decreasing the limestone content.When the ceiling clearance of the hydro-cyclone was changed, an optimum ceiling clearance for obtaining a minimal cut size was found.A model for predicting the slurry concentration that is proportional to the solid throughput of a hydro-cyclone and the improvement in gypsum purity in an actual plant is proposed. The results of this calculation model agreed well with experiment data.
- 社団法人 化学工学会の論文
- 2004-06-01
著者
-
Yoshida Hideto
Department Of Chemical Engineering Graduate School Of Engineering Hiroshima University
-
Yoshida Hideto
Department Of Chemical Engineering Hiroshima University
-
TAKASHINA Toru
Hiroshima Research & Development Center, Mitsubishi Heavy Industries, Ltd.
-
Takashina Toru
Hiroshima Research And Development Center Mitsubishi Heavy Industries Ltd.
-
Kobayashi K
Hiroshima Research And Development Center Mitsubishi Heavy Industries Ltd.
-
KOBAYASHI Kazuto
Hiroshima Research and Development Center, Mitsubishi Heavy Industries, Ltd.
関連論文
- Effect of Inlet Duct Shape on Particle Separation Performance of Cyclone Separator
- Particle size measurement of standard reference particle candidates and theoretical estimation of uncertainty region
- Enhancement of the Classification Performance of Electrical Field-Flow Fractionation Using Horizontal Electrophoresis
- Influence of inlet flow rate, pH, and beads mill operating condition on separation performance of sub-micron particles by electrical hydrocyclone
- Effect of Limestone Concentration and Particle Size on SO_2 Absorption in Wet FGD Process
- Rapid and simultaneous determination of multi-element abundances and U-Pb age for zircon crystal using UV laser ablation ICP-MS technique: critical evaluation of the technique with 91500 zircon standard
- Particle size measurement of standard reference particle candidates with improved size measurement devices
- Effects of initial slurry concentration distribution on the particle size distribution measured with a sedimentation balance method
- Synthesis of indium tin oxide powder by solid-phase reaction with microwave heating
- Continuous fine particle classification by water elutriator with applied electro-potential
- Utilization of NaCl for phillipsite synthesis from fly ash by hydrothermal treatment with microwave heating
- Classification of Particles Dispersed by Bead Milling Using Electrical Field-Flow Fractionation
- Effect of Multi-Inlet Flow on Particle Classification Performance of Hydro-Cyclones and New Estimating Equation
- Effects of microwave irradiation on the crystalline phase of zeolite synthesized from fly ash by hydrothermal treatment
- Investigation about Data Reduction and Sedimentation Distance of Sedimentation Balance Method
- Phillipsite synthesis from fly ash prepared by hydrothermal treatment with microwave heating
- Effect of apex cone height on particle classification performance of a cyclone separator
- Particle size measurement with an improved sedimentation balance method and microscopic method together with computer simulation of necessary sample size
- Effect of Ammonium Concentration on SO_2 Absorption in a Wet Limestone Gypsum FGD Process
- Particle Separation with a Hydro-Cyclone Separator in a Wet Limestone Gypsum FGD Process
- Separation of Unburned Carbon in Fly Ash Particles Using Special Louver Separator
- Classification of Particles Dispersed by Bead Milling Using Electrical Field-Flow Fractionation
- Meteor Storm Activity and Average Size of Meteoroids for the 2001 Leonids by FM Broadcasting Radio Observation
- Effect of Blade Angle on Crystallinity Change in a Mechanical Impact Mill
- Comparison of separation performance between single and two inlets hydrocyclones
- Theoretical calculation of fundamental uncertainty region based on the maximum and/or the minimum size in the preparation of standard reference particles for particle size measurement
- Enhancement of the Classification Performance of Electrical Field-Flow Fractionation Using Horizontal Electrophoresis
- Classification of particles by centrifugal separator and analysis of the fluid behavior
- Environmental Transmission Electron Microscopy Observations of Swinging and Rotational Growth of Carbon Nanotubes
- Separation of Unburned Carbon in Fly Ash Particles Using Special Louver Separator
- Carbon Beads on Semiconductor Nanowires
- Size classification of submicron powder by air cyclone and three-dimensional analysis.
- The effect of initial parameters on particle size distribution inverted using the laser diffraction technique and a non-linear iterative method
- Theoretical calculation of uncertainty region based on the general size distribution in the preparation of standard reference particles for particle size measurement