Yoshida Hideto | Department Of Chemical Engineering Graduate School Of Engineering Hiroshima University

スポンサーリンク

概要

関連著者

もっと見る

著作論文

Effect of Inlet Duct Shape on Particle Separation Performance of Cyclone Separator
Particle size measurement of standard reference particle candidates and theoretical estimation of uncertainty region
Enhancement of the Classification Performance of Electrical Field-Flow Fractionation Using Horizontal Electrophoresis
Influence of inlet flow rate, pH, and beads mill operating condition on separation performance of sub-micron particles by electrical hydrocyclone
Rapid and simultaneous determination of multi-element abundances and U-Pb age for zircon crystal using UV laser ablation ICP-MS technique: critical evaluation of the technique with 91500 zircon standard
Particle size measurement of standard reference particle candidates with improved size measurement devices
Effects of initial slurry concentration distribution on the particle size distribution measured with a sedimentation balance method
Synthesis of indium tin oxide powder by solid-phase reaction with microwave heating
Continuous fine particle classification by water elutriator with applied electro-potential
Utilization of NaCl for phillipsite synthesis from fly ash by hydrothermal treatment with microwave heating
Classification of Particles Dispersed by Bead Milling Using Electrical Field-Flow Fractionation
Effect of Multi-Inlet Flow on Particle Classification Performance of Hydro-Cyclones and New Estimating Equation
Effects of microwave irradiation on the crystalline phase of zeolite synthesized from fly ash by hydrothermal treatment
Investigation about Data Reduction and Sedimentation Distance of Sedimentation Balance Method
Phillipsite synthesis from fly ash prepared by hydrothermal treatment with microwave heating
Effect of apex cone height on particle classification performance of a cyclone separator
Particle size measurement with an improved sedimentation balance method and microscopic method together with computer simulation of necessary sample size
Particle Separation with a Hydro-Cyclone Separator in a Wet Limestone Gypsum FGD Process
Separation of Unburned Carbon in Fly Ash Particles Using Special Louver Separator
Classification of Particles Dispersed by Bead Milling Using Electrical Field-Flow Fractionation
Meteor Storm Activity and Average Size of Meteoroids for the 2001 Leonids by FM Broadcasting Radio Observation
Effect of Blade Angle on Crystallinity Change in a Mechanical Impact Mill
Comparison of separation performance between single and two inlets hydrocyclones
Theoretical calculation of fundamental uncertainty region based on the maximum and/or the minimum size in the preparation of standard reference particles for particle size measurement
Enhancement of the Classification Performance of Electrical Field-Flow Fractionation Using Horizontal Electrophoresis
Classification of particles by centrifugal separator and analysis of the fluid behavior
Environmental Transmission Electron Microscopy Observations of Swinging and Rotational Growth of Carbon Nanotubes
Separation of Unburned Carbon in Fly Ash Particles Using Special Louver Separator
Carbon Beads on Semiconductor Nanowires
Size classification of submicron powder by air cyclone and three-dimensional analysis.
The effect of initial parameters on particle size distribution inverted using the laser diffraction technique and a non-linear iterative method
Theoretical calculation of uncertainty region based on the general size distribution in the preparation of standard reference particles for particle size measurement

もっと見る

スポンサーリンク