電力ケーブルの水トリー劣化位置標定を目指したパルス応答測定

概要

論文の詳細を見る
Water treeing is a degradation mode of power cable with polymeric insulation. A water tree is composed of small droplets filled with water. As the conductivity in water tree is very high, it leads to dielectric breakdown when it grows up. As inside of the water tree is filled with trap sites, it is polarized with a certain distribution of relaxation time when a DC poling voltage is applied. Although its depolarization process after removing the poling voltage is determined by ambient temperature, applying a “depolarizing voltage” with the opposite polarity can accelerate the process. If a short pulse propagating through the cable is employed as a depolarization voltage, we may locate the water tree through looking at the time-resolved pulse response. This would lead to a diagnosing method with spatial resolution. In order to retain 100 m of spatial resolution, the response should be as sharp as 1 μs. As a preliminary study, a coaxial communication cable was aged to form water trees. A DC poling voltage was applied followed by a pulse voltage with opposite polarity. The rising time of the pulse was several hundreds of microseconds. A sharp pulse current response with 50 μs in width was observed, suggesting that a rapid depolarization took place. No such response was seen when the cable specimen was not aged. We concluded that the technique is quite feasible. As the response was found to be as quick as several microseconds, an experiment using 405 m-long cable, with 5 m of degraded length in the middle, was performed. It was shown that the degraded point was successfully located.
電気学会の論文
2011-06-01

電力ケーブルの水トリー劣化位置標定を目指したパルス応答測定

スポンサーリンク

概要

著者

関連論文

スポンサーリンク