Analysis of Raw Material Flow with Axial Direction in Continuous Drum Mixer for Sintering Process
スポンサーリンク
概要
- 論文の詳細を見る
The granulation process is known to be important to achieve high productivity in sinter process because the granulation of sinter mixture is connected with permeability of sinter bed. Past studies on the granulation in the drum mixer for sintering process mostly used the batch type drum mixer, hence their studies were on the raw material behavior for cross-section of the drum mixer. In contrast there were few reported on the raw material behavior for a drum axial and a residence time in a continuous type drum mixer. The raw material flows and the residence times have been investigated experimentally by using a continuous type drum mixer, and results were compared to those by the theory predicts suggested by Saeman. In addition, the effects of the ring dam fitted to the discharge end on the residence time and granulation improvement were investigated. As a result, with the drum set at the low angle, the observed residence times were shorter than the theory predicts. This is due to the level of the raw material tapering off as it reaches the discharge end. Thus, by newly considering angle ψ between the raw material surface and the drum mixer, the residence time was accurately estimated. Also, with the drum set the low angle, the ring dam fitted to the discharge end prevented any tapering, resulting in the longer residence time and greatly improved granulation.
- 2009-05-15
著者
-
KAWAGUCHI Takazo
Corporate Research & Development Laboratories, Sumitomo Metal Industries, Ltd.
-
Hara Masaki
Corporate R&d Sumitomo Metal Industries Ltd.
-
MATSUMURA Masaru
Head office, Sumitomo Metal Industries, Ltd.
-
KAMIJO Chikashi
Corporate R&D, Sumitomo Metal Industries, Ltd.
-
Kamijo Chikashi
Corporate R&d Sumitomo Metal Industries Ltd.
-
Kawaguchi Takazo
Sumitomo Metal Industries Ltd.
-
Kawaguchi Takazo
Corporate R&d Laboratories Sumitomo Metal Industries Ltd.
-
Matsumura Masaru
Head Office Sumitomo Metal Industries Ltd.
-
KAWAGUCHI Takazo
Corporate R&D, Sumitomo Metal Industries, Ltd.
-
Kamijo Chikashi
Corporate R&D Laboratories, Sumitomo Metal Industries, Ltd.
関連論文
- Analysis of Raw Material Flow with Axial Direction in Continuous Drum Mixer for Sintering Process
- Properties of Core Ore in Quasi-particle Required for Large Amounts Usage of Limonitic Ores in Iron Ore Sintering Process
- Carbothermic Reduction in the Combustion Bed Packed with Composite Pelles of Iron Oxide and Coal
- Analysis of Granules Behavior in Continuous Drum Mixer by DEM
- Numerical Simulation Model for Granulation Kinetics of Iron Ores
- Production of direct reduced iron by a sheet material inserting metallization method
- Production of direct reduced iron by sheet material inserting metallization method
- Development of a 3-D Sinter Process Mathematical Simulation Model
- Influence of Properties of Fluxing Materials on the Flow of Melt Formed in the Sintering Process
- Effect of Test Condition on Decrepitation Index and Test Repeatability for Lump Iron Ore
- Improvement of Sinter Softening Property and Reducibility by Controlling Chemical Compositions
- Production of Carbon Included Sinter and Evaluation of Its Reactivity in a Blast Furnace Environment
- Sintering Behavior of Raw Material Bed Placing Large Particles
- Summarized Achievements of the Porous Meso-mosaic Texture Sinter Research Project
- Improvement of Sinter Productivity by Adding Return Fine on Raw Materials after Granulation Stage