Preparation of Carbonized Biomass Water Mixture and Upgraded Coal Water Mixture
スポンサーリンク
概要
- 論文の詳細を見る
Biomass is the third largest primary energy resource in the world after coal and oil. Due to its huge potential, the renewable and the corresponding positive role for CO2 reduction, the use of carbonized biomass for energy purpose is expected to increase. The carbonized biomass comes from agricultural waste and forest by-product. Carbonized plant and carbonized coconut cell biomass were mixed with water to study the possibilities of slurry preparation as a carbonized biomass water mixture (CBWM). Beside that, the upgraded coal by an upgraded brown coal (UBC) process was also studied to produce a UBC water mixture (UBCWM) with high coal concentration. The rheological characteristics of CBWM and UBCWM have been conducted by using a stress controlled rheometer. The results indicate that the maximum concentrations of the carbonized plant, carbonized coconut cell biomass, and UBC were 35.9, 51.2, and 61.5 wt%, when respectively using 0.3 wt% of naphthalene sulfonic acid (NSF), polymethacrylate (PMA), and NSF as dispersing additives, and 0.1 wt% of carboxyl methyl cellulose (CMC) as a stabilizing additive.
- 社団法人 化学工学会の論文
- 2006-11-01
著者
-
KOMODA Yoshiyuki
Department of Chemical Science and Engineering, Kobe University
-
Usui Hiromoto
Department Of Applied Chemistry And Chemical Engineering Yamaguchi University
-
Komoda Yoshiyuki
Department Of Chemical Science And Engineering Kobe University
-
Komoda Yoshiyuki
Department Of Chemical Science And Engineering Graduate School Of Engineering Science Osaka Universi
-
UMAR Datin
Research and Development Center for Mineral and Coal Technology
-
DAULAY Bukin
Research and Development Center for Mineral and Coal Technology
関連論文
- Emulsion Polymerization of Vinyl Acetate in a System of Two CSTR in Series
- Effect of the Composition and Coating Condition on the Structure and Performance of Catalyst Layer of PEFC
- Dispersion Control of Nano-Particles and the Effect of the Coating Condition on the Performance of Proton-Exchange Membrane Fuel Cells (PEMFCs)
- Structure Analysis of Drag-Reducing Surfactant Rod-Like Micelles with Fluorescence Probe
- Biaxial Extensional Characteristics of Drag-Reducing Surfactant Solution
- Surfactant Drag Reduction Caused by a Cationic Surfactant with Excess Addition of Counter-ions
- Particle Size Characteristics of Ice Slurry Treated with Surfactants and Brines
- Effect of Shear Rate and Volume Fraction on Agglomerative Nature of Polymer Latex
- A Folw Visualization Study on the Mechanism of Turbulent Drag Reduction by Surfactants
- Surfactant Drag Reduction in Internally-Grooved Rough Tubes
- EFFECT OF MOLECULAR STRUCTURE OF POLYSACCHARIDE ON THE STABILITY OF COAL-WATER MIXTURES
- DRAG REDUCTION AND HEAT TRANSFER REDUCTION BY CATIONIC SURFACTANTS
- COAGULATION AND DISPERSION CHARACTERISTICS OF COAL WATER MIXTURES IN HIGHER TEMPERATURE RANGE
- Viscosity Prediction of Dense Slurries Prepared by Non-Spherical Solid Particles
- Investigation of Thermal Properties of Na_2HPO_4 Hydrate Slurries for Evaluating Their Use as a Coolant in Absorption Chillers
- Agglomeration of Hydrate Particles in Aqueous Surfactant Solution with Counter-Ion
- Improvement of Thixotropy Model Analyzing Dispersion Characteristics of Fine Particles in Newtonian Molten Polymer
- Model analysis on dispersion characteristics of fine particles in Newtonian molten polymer
- Behavior of Fine Particle Agglomerates in a Newtonian Molten Polymer Under a Shear Flow
- Size Characteristics of Liposomes Formed in a Micro-Tube
- Mixing Mechanism of a Multi-Holed Static Mixer
- Optimization of Preparation and Drying Conditions of Titanium Dioxide Slurry for Coating on a Plastic Substrate
- Mixing Characteristics of Newtonian Fluid by a Multi-Holed Static Mixer
- Viscosity measuring technique for gas-solid suspensions
- Viscosity Prediction of Dense Slurries with Agglomerative Coal Particles
- Effect of Cetyldimethylbetaine Molecules on Agglomeration and Growth of Ice
- Hydrodynamics and Heat Transfer Characteristics of Drag-Reducing Trimethylolethane Solution and Suspension by Cationic Surfactant
- Turbulent flow in an isosceles triangular duct
- Onion-like Structure Flow of Viscoelastic Surfactant Solutions Induced by 4-Blade Paddle Impeller in a Vessel
- BP-O3 Visualization of liposome production in a micro-tube(Section II Biopharmaceuticals Production)
- The Effect of Shear Rate on Heteroaggregation Behavior of Latex Polymers and Suspension Polymers in Aqueous Media
- Drying of Coated Slurry in Vapor of Drying Solvent
- The Effect of the Swelling Rate of Latex Particle on Assembly Morphology in Seed Coagulation by Monomer Droplets
- Preparation of Carbonized Biomass Water Mixture and Upgraded Coal Water Mixture
- Suppression of Ice Particle Growth and the Possibility of Energy Saving Latent Heat Transportation by Using Surfactant Additives
- Numerical Study on the Drawing of Polymer Optical Fibers in Steady State
- Improvement of Devolatilization and Control of Low-temperature Oxidation by Vacuum Drying and Tar Coating Treatments of Low-rank Coal
- F305 INTENSIFICATION OF DISSIMILARITY BETWEEN HEAT AND MOMENTUM TRANSFER IN A DUCT FLOW WITH TEMPERATURE-CONTROLLED INJECTION/SUCTION FROM THE WALLS(Control of turbulent mixing process)
- Numerical Computations on Heat Transfer Characteristics from the Cavity Bottom in Parallel Plates Swept by Viscoelastic Fluid
- Numerical Experiments on Heat Transfer Characteristics in a Cavity Swept by Visco-Elastic Fluid
- Prediction of Flow Characteristics of Whipped Cream under Pressurized Condition
- Characteristics of Turbulent Flow Induced by Reciprocating Disk in Cylindrical Vessel
- Particle Size Depression and Drag Reduction of Ice Slurry Treated with Combination Additives of Surfactants and Poly(vinyl alcohol)
- Characteristics of Laminar Flow Induced by Reciprocating Disk in Cylindrical Vessel
- Mixing Performance by Reciprocating Disk in Cylindrical Vessel
- Numerical Study on Non-Absorbable Gas Control Using an Immersed Plate and Extraction in Evaporator/Absorber of Absorption Chiller
- Effect of Molar Ratio of Counter-Ions to Cationic Surfactants Treating Trimethylolethane Hydrate Slurries
- Effect of temperature on the fluidity of a coal water mixture
- Flow and Heat Transfer Characteristics of Ammonium Alum Hydrate Slurries Treated with Surfactants
- Drag reduction with heterogeneous polymer injection into a turbulent pipe flow
- Turbulent round jet submerged in dilute drag reducing polymer solutions
- Structure Analysis of Drag-Reducing Surfactant Rod-Like Micelles with Fluorescence Probe
- Biaxial Extensional Characteristics of Drag-Reducing Surfactant Solution
- Prediction of Dispersion Characteristics and Rheology in Dense Slurries
- Onion-Like Structure of Viscoelastic Surfactant Solution Flow Induced by 4-Blade Paddle Impeller in a Vessel
- Flow and Heat Transfer Characteristics of Ammonium Alum Hydrate Slurry Treated with Surfactants
- Fluid Deformation Induced by a Rotationally Reciprocating Impeller
- Fully developed turbulent mass transfer in a triangular duct with a narrow apex angle.
- Laser-doppler measurements of turbulence structure in a drag-reducing pipe flow with polymer injection.