All Solid-state Lithium Secondary Batteries Using High Lithium Ion Conducting Li_2S-P_2S_5 Glass-Ceramics

スポンサーリンク

概要

• 論文の詳細を見る
• 2002-12-05

著者

• Minami T

  Osaka Prefecture Univ. Jpn

• Minami Tsutomu

  Department Of Applied Chemistry University Of Osaka Prefecture

• Minami T

  Department Of Applied Materials Science Graduate School Of Engineering Osaka Prefecture University

• Minami Tsutomu

  Department Of Applied Chemistry College Of Engineering University Of Osaka Prefecture

• Tadanaga Kiyoharu

  Department of Applied Materials Science, Graduate School of Engineering, Osaka Prefecture University

• Hayashi Akio

  Nippon Oil & Fats Co. Ltd.

• Hama S

  Department Of Applied Materials Science Graduate School Of Engineering Osaka Prefecture University

• TATSUMISAGO Masahiro

  Department of Applied Chemistry, Graduate School of Engineering, Osaka Prefecture University

• HAMA Shunichi

  Department of Industrial Chemistry, Faculty of Engineering, The University of Tokyo

• MIZUNO Fuminori

  Department of Applied Materials Science, Graduate School of Engineering, Osaka Prefecture University

• HAMA Shigenori

  Department of Applied Materials Science, Graduate School of Engineering, Osaka Prefecture University

• HAYASHI Akitoshi

  Department of Applied Materials Science, Graduate School of Engineering, Osaka Prefecture University

• Tatsumisago M

  Dep. Of Applied Chemistry Graduate School Of Engineering Osaka Prefecture Univ.

• Tatsumisago Masahiro

  Department Of Applied Chemistry University Of Osaka Prefecture

• Mizuno Fuminori

  Department Of Applied Materials Science Graduate School Of Engineering Osaka Prefecture University

• Minami T

  Osaka Prefecture Univ. Osaka

• Hayashi Akitoshi

  Department Of Applied Chemistry Osaka Prefecture University

• Tatsumisago Masahiro

  Department Of Applied Chemistry Osaka Prefecture University

• TADANAGA Kiyoharu

  Department of Applied Chemistry, Graduate School of Engineering Osaka Prefecture University

関連論文

• Lowering the Crystallization Temperature of YMnO_3 Thin Films by the Sol-Gel Method Using an Yttrium Alkoxide
• Preparation and characterization of superionic conducting Li7P3S11 crystal from glassy liquids
• YMnO_3 Thin Films Prepared from Solutions for Non Volatile Memory Devices
• Infrared Spectra of Amorphous As_2S_3 Films Deposited at Different Temperatures
• Electron-Beam-Induced Current in Amorphous Chalcogenide Film/Crystalline Silicon Heterojunctions
• Thermoelectric Power of Si-As-Te and Ge-As-Te Glasses
• Highly Transparent and Conductive Zinc-Stannate Thin Films Prepared by RF Magnetron Sputtering
• Transparent and Conductive ZnO Thin Films Prepared by Atmospheric-Pressure Chemical Vapor Deposition Using Zinc Acetylacetonate
• Large-Area Milky Transparent Conducting Al-Doped ZnO Films Prepared by Magnetron Sputtering
• Reactive Ion Etching Using Electron Cyclotron Resonance Hydrogen Plasma with n-Butyl Acetate Reactive Gas : Etching
• Reactive Ion Etching Using Electron Cyclotron Resonance Hydrogen Plasma with n-Butyl Acetate Reactive Gas
• Substrate Temperature Dependence of Transparent Conducting Al-Doped ZnO Thin Films Prepared by Magnetron Sputtering
• 20II-P-17 Hydrophobic and Photocatalytically Active Surface Using Micropatterns of Anatase Nanocrystals-Dispersed Film
• 13-O-01 Micropatterning of Inorganic-Organic Thick Hybrid Coating Films from Vinyltriethoxysilane
• 09-P-31 Preparation of Li_2S-P_2S_5 Based Glass-Ceramic Solid Electrolytesand their Application to All-Solid-State Lithium Secondary Batteries
• 09-O-18 Lithium Ion Conducting Glasses and Glass-Ceramics in the Systems Li_2S-M_xS_y (M=Al, Si and P) Prepared by Mechanical Milling
• 09-O-17 Characterization of SnO-M_xO_y (M=B and P) Glassy Anode Materials for Lithium Secondary Batteries Prepared by Melt-Quenching and Mechanical Milling
• 03-P-26 Formation of Anti-Reflective Alumina Coating Films on Polymer Substrates by the Sol-Gel Process with Hot Water Treatment
• Effect of Alkanolamines on the Microstructure and Dielectric Properties of Lead Zirconium Titanium Trioxide Thin Films Prepared from Modified Metal Alkoxides
• ^Al NMR Study of Coordination States of Aluminum-tri-sec-butoxide Dissolved in Diacetone Alcohol
• Effect of Driving Frequency on the EL Characteristics of Thick Ceramic Insulating Type TFEL Devices Using Y_2O_3-Based Phosphor Emitting Layer(Electronic Displays)
• Platelike Crystal Growth of Zn-Al Layered Double Hydroxide by Hot Water Treatment of Sol-Gel Derived Al_2O_3-ZnO Films on Glass Substrate
• Mixed Anion Effect on Conductivity of the Glasses in the System AgI-Ag_2MoO_4-AgPO_3
• Photolysis of Organically Modified Gel Films and its Application to the Fine-patterning of Oxide Thin Films
• Fine-Patterning of ZrO_2 Thin Films by the Photolysis of Chemically Modified Gel Films
• Highly Conducting and Transparent SnO_2 Thin Films Prepared by RF Magnetron Sputtering on Low-Temperature Substrates : Surfaces, Interfaces and Films
• Alkynyldichlorogalliums are Unstable in Hydrocarbon Solvents Dimerization of Alkynyldichlorofalliums via Carbogallation
• Structure of Adduct Formed from α-Trichlorostannyl Ketone and Trichloroethynyltin a Direct Evidence for the Carbostannylation of Alkynyl Metals
• Direct Formation of Reactive Alkynyltrichlorotins from 1-Alkynes SnCl_4, and Bu_3N. A Mild Alkynylation Reagent of Aldehydes, Acetals, and Enones
• Highly Transparent and Conductive Zn_2In_2O_5 Thin Films Prepared by RF Magnetron Sputtering
• Preparation of Proton Conductive Phosphosilicate Gels Derived from 2-(Diethoxyphosphoryl)ethyltriethoxysilane
• High-Luminance Green Zn_2SiO_4:Mn Thin-Film Electroluminescent Devices Using an Insulating BaTiO_3 Ceramic Sheet
• Flat Panel Light-Emitting Sounder Using Thin-Film EL Devices with a Ceramic Insulating Layer
• Preparation of Bi-Pb-Ca-Sr-Cu-O Superconducting Thick Films Using Spray-Pyrolyzed Fine Powders
• Direct Preparation of Fine Powders of the 80 K Superconducting Phase in the Bi-Ca-Sr-Cu-O System by Spray Pyrolysis
• Direct Preparation of Uniformly-Distributed YBa_2Cu_3O_ Powders by Spray-Pyrolysis : Electrical Properties of Condensed Matter
• Optical Properties of Aluminum Doped Zinc Oxide Thin Films Prepared by RF Magnetron Sputtering
• Highly Conductive and Transparent Aluminum Doped Zinc Oxide Thin Films Prepared by RF Magnetron Sputtering
• Dehydrogenation of Cycloalkanes by Suspended Platinum Catalysts
• All Solid-state Lithium Secondary Batteries Using High Lithium Ion Conducting Li_2S-P_2S_5 Glass-Ceramics
• High Lithium Ion Conductivity of Glass-Ceramics Derived from Mechanically Milled Glassy Powders
• Electroluminescent Devices with Ga_2O_3 : Mn Thin-Film Emitting Layer Prepared by Sol-Gel Process
• Effects of Sb or Sn Addition on Precipitation of the High-T_c Superconducting Phase from Rapidly Quenched Bi-Pb-Ca-Sr-Cu-O Glasses
• Crystalline Phases Precipitated by Heat-Treatment of Rapidly-Quenched Glasses in the Bi-Ca-Sr-Cu-O System
• Substitution Effects of Pb for Bi on the Formation of High-T_c Superconducting Thick Films in the Bi-Pb-Ca-Sr-Cu-O System by the Melt-Solidification Method
• Instantaneous Preparation of Superconducting Thick Films through Melts in the Bi-Ca-Sr-Cu-O System : Electrical Properties of Condensed Matter
• Glass Formation of High-T_c. Compound BiCaSrCu_2O_x by Rapid Quenching : Electrical Properties of Condensed Matter
• Inflence of Size of Dispersed Silica Particles on Preparation of Thick Silica Films by Using Electrophoretic Sol-Gel Deposition
• Thermal Expansion and Its Related Properties of Arsenic-Sulfur Glasses
• Formation and Properties of Ferroelectric Bi_4Ti_3O_ Films by the Sol-Gel Process
• Relationship of Composition and Density of Arsenic-Sulfur Glasses
• Preparation and Characterization of Lithium Ion Conducting Glass-Polymer Composites
• Preparation of Super-Water-Repellent Alumina Coating Film with High Transparency on Poly(ethylene terephthalate)by the Sol-Gel Method
• Proton Conductive Silica Gels Doped with Several Acids and Their Application to Electric Double-Layer Capacitor
• Structure of Rapidly Quenched Li_2O-SiO_2 Glasses(Materials, Metallurgy & Weldability)
• "Synthesis and Polymerization of Macromonomer Having a Phospholipid Polar Group"
• Synthesis and Polymerization of Macromonomer Having a Phospholipid Polar Group
• Infrared Absorption Band near 12.51μ of Arsenic-Sulfur Glasses
• Stabilization of Superionic α-AgI at Room Temperature by Heating of AgI-Ag_2O-MoO_3 Glasses
• Substituent effects on the glass transition phenomena of polyorganosilsesquioxane particles prepared by two-step acid–base catalyzed sol–gel process
• Preparation of Thick Inorganic-organic Composite Films by Electrophoretic Sol-gel Deposition Using Organically Modified Silica Particles and Polyethylene Maleate
• Coprecipitation of Trace Metal Ions with Scandium Hydroxide for Graphite Furnace Atomic Absorption Spectrometry
• Preparation and Characterization of Polyaminophenylsilsesquioxane Particles by Two-step Acid-Base-catalyzed Sol-Gel Process
• Preparation of needle-like α-Fe2O3 particles and influences of their morphology on the electrochemical behavior in all-solid-state lithium batteries
• SnP0.94 active material synthesized in high-boiling solvents for all-solid-state lithium batteries
• Effects of Phenyltriethoxysilane Concentration in Starting Solutions on Thermal Properties of Polyphenylsilsesquioxane Particles Prepared by a Two-Step Acid-Base Catalyzed Sol-Gel Process
• All-solid-state Lithium Secondary Batteries Using Li_2S-P_2S_5 Solid Electrolytes and LiFePO_4 Electrode Particles with Amorphous Surface Layer
• LiS-PS系薄膜セパレータを用いたバルク型全固体リチウム二次電池
• Li電極とLiS-PS系固体電解質の界面にインジウム薄膜を備えたバルク型リチウム金属二次電池
• Amorphous Titanium Sulfide Electrode for All-solid-state Rechargeable Lithium Batteries with High Capacity
• Glass Electrolytes with High Ion Conductivity and High Chemical Stability in the System LiI-Li2O-Li2S-P2S5

もっと見る 閉じる

スポンサーリンク