Precision Machining by Feedback of Shape Data (1st Report) -The Basic Concept and Examples of Corrective Machining-

スポンサーリンク

概要

論文の詳細を見る
1999-09-30

著者

関連論文

411 TiC Accretion Process by Electrical Discharge Machining with Ti Powder Suspended in Working Oil
Machining Characteristics Using Different Kinds of Working Fluid(Second Report)
Machining Characteristics Using Different Kinds of Working Fluid (First Report)
C-13 EFFECT OF GRAPHITE ELECTRODE ON ALUMINA'S EDM PROPERTIES(Session: EDM/MIM)
Tribological Properties of TiC Hard Layer by EDM
Tribological Properties of TiC Hard Layer by EDM
Effects of Structural Orientation on EDM Properties of Sapphire
Planarization of a Layer Made by Using Electrical Discharge Machining
Micro Hole Electrical Discharge Machining on Insulating Ceramics with Pipe Electrode
506 Planarization of a layer made by using electric discharge machining
Formation of TiC/Ti_2AlC Composite Layer and Improvement on Surface Roughness
Precision Machining by Feedback of Shape Data (1st Report) -The Basic Concept and Examples of Corrective Machining-
Formation of Composite Layer Containing TiC Precipitates by Electrical Discharge Alloying
Incorporation of Alumina Particles with Different Shapes and Sizes into Molten Aluminum Alloy by Melt Stirring with Ultrasonic Vibration
In-process Measurement of Grinding Wheel by Hydrodynamic Pressure (4th Report) : Automating compensation process for grinding wheel wear
429 Compensation for grinding wheel wear by pressure based in-process measurement in wet grinding
Modal Analysis of Wire Electrode Vibration in Wire-EDM

もっと見る

スポンサーリンク