Micro Hole Electrical Discharge Machining on Insulating Ceramics with Pipe Electrode
スポンサーリンク
概要
- 論文の詳細を見る
- 2003-01-01
著者
-
MOHRI Naotake
Toyota Technological Institute
-
Mohri N
The University Of Tokyo
-
Mohri Naotake
Tokyo University
-
Mohri Naotake
Department Of Precision Engineering The University Of Tokyo
-
Fukuzawa Yasushi
Nagaoka University of Technology
-
Tani Takayuki
Tsukuba College Technology
-
MUTTAMARA Apiwat
Department of Mechanical Engineering, Nagaoka University of Technology
-
FUKUZAWA Yasushi
Department of Mechanical Engineering, Nagaoka University of Technology
-
TANI Takayuki
Department of Mechanical Engineering, Tsukuba College of Technology
-
Apiwat Muttamara
Faculty Of Engineering Thammasat University
-
Fukuzawa Yasushi
Department Of Mechanical Engineering Nagaoka University Of Technology
関連論文
- Machining Characteristics Using Different Kinds of Working Fluid(Second Report)
- Machining Characteristics Using Different Kinds of Working Fluid (First Report)
- C-13 EFFECT OF GRAPHITE ELECTRODE ON ALUMINA'S EDM PROPERTIES(Session: EDM/MIM)
- Tribological Properties of TiC Hard Layer by EDM
- Tribological Properties of TiC Hard Layer by EDM
- Effects of Structural Orientation on EDM Properties of Sapphire
- Planarization of a Layer Made by Using Electrical Discharge Machining
- Micro Hole Electrical Discharge Machining on Insulating Ceramics with Pipe Electrode
- 506 Planarization of a layer made by using electric discharge machining
- Formation of TiC/Ti_2AlC Composite Layer and Improvement on Surface Roughness
- Precision Machining by Feedback of Shape Data (1st Report) -The Basic Concept and Examples of Corrective Machining-
- Formation of Composite Layer Containing TiC Precipitates by Electrical Discharge Alloying
- Incorporation of Alumina Particles with Different Shapes and Sizes into Molten Aluminum Alloy by Melt Stirring with Ultrasonic Vibration
- A Study on Single Discharge Machining with Low Melting Temperature Alloy : The Relationship between removal volume of crater and single dischage conditions
- Development of Surface Machining by EDM
- B22 Deformation Analysis of Polycarbonate Sheet with Flexible Underlay During Wedge Cutting Process(Advanced machining technology)
- 513 Cutting characteristic of a unique double structure cutter in relation with applied loads
- 319 Effect of Tip Thickness on Cutting Workability of Trapezoidal Bevel Blade Indented to Aluminum Sheet
- Cutting Mechanism and Load Characteristic of Trapezoidal Center Bevel Cutter Indented on Aluminum Sheet(Advanced Manufacturing Technology)
- Modal Analysis of Wire Electrode Vibration in Wire-EDM
- Tensile Characteristics of Connecting Portions of Paperboard Subjected to Indentation of Nicked Center Bevel Blade
- Mechanical Characteristics of Center Bevelled Double Structure Blade
- Effects of the Edm Combined Ultrasonic Vibration on the Machining Properties of Si_3N_4
- Machining of hard materials by the EDM combined ultrasonic vibration method (第199回電気加工研究会)
- Surface Modification of Stainless Steel by Electrical Discharge Machining.
- Effect of Hardness Combination on Contact Deformation of Center Bevel Blade with Counter Plate Subjected to a Pushing Load
- Finite Element Analysis of Cutting Deformation of Stacked Polycarbonate Sheets Subjected to Two-Line Wedge Indentation
- Effect of Insulating Si_3N_4 Ceramics on Removal Rate by EDM with Piezoelectric Device