C-13 EFFECT OF GRAPHITE ELECTRODE ON ALUMINA'S EDM PROPERTIES(Session: EDM/MIM)
スポンサーリンク
概要
- 論文の詳細を見る
As previously reported , several insulating ceramics such as Si_3N_4, SiC and ZrO_2 have successfully been machined by EDM. As unstable discharges occur during the machining of Al_2O_3 ceramics, inferior machining properties have been obtained as compared to other ceramics. In this study, semi-sintered graphite electrode and copper infiltrated graphite electrode were carried out on 95% of alumina. Graphite and graphite plus copper electrode improved machining rate.
- 2006-11-08
著者
-
MOHRI Naotake
Toyota Technological Institute
-
Mohri N
The University Of Tokyo
-
Mohri Naotake
Tokyo University
-
Apiwat Muttamara
Faculty of Engineering, Thammasat University
-
Fukuzawa Yasushi
Nagaoka University of Technology
-
Tani Takayuki
Tsukuba College Technology
-
Apiwat Muttamara
Faculty Of Engineering Thammasat University
関連論文
- Machining Characteristics Using Different Kinds of Working Fluid(Second Report)
- Machining Characteristics Using Different Kinds of Working Fluid (First Report)
- C-13 EFFECT OF GRAPHITE ELECTRODE ON ALUMINA'S EDM PROPERTIES(Session: EDM/MIM)
- Tribological Properties of TiC Hard Layer by EDM
- Tribological Properties of TiC Hard Layer by EDM
- Effects of Structural Orientation on EDM Properties of Sapphire
- Planarization of a Layer Made by Using Electrical Discharge Machining
- Micro Hole Electrical Discharge Machining on Insulating Ceramics with Pipe Electrode
- 506 Planarization of a layer made by using electric discharge machining
- Formation of TiC/Ti_2AlC Composite Layer and Improvement on Surface Roughness
- Precision Machining by Feedback of Shape Data (1st Report) -The Basic Concept and Examples of Corrective Machining-
- Formation of Composite Layer Containing TiC Precipitates by Electrical Discharge Alloying
- Incorporation of Alumina Particles with Different Shapes and Sizes into Molten Aluminum Alloy by Melt Stirring with Ultrasonic Vibration
- Modal Analysis of Wire Electrode Vibration in Wire-EDM
- Tensile Characteristics of Connecting Portions of Paperboard Subjected to Indentation of Nicked Center Bevel Blade