Subsurface Crack Generation in High-cycle Fatigue for High Strength Alloys
スポンサーリンク
概要
- 論文の詳細を見る
- 1997-12-15
著者
-
Nagai K
National Inst. For Materials Sci. Tsukuba Jpn
-
Nagai Kotobu
National Inst. Materials Sci. Tsukuba Jpn
-
Umezawa Osamu
National Institute For Materials Science
-
Umezawa Osamu
National Research Institute For Metals Sengen Tsukuba
-
Nagai K
Metallurgical Processing Group Steel Research Center National Institute For Materials Science
-
Nagai Kotobu
National Inst. For Materials Sci.
関連論文
- Characteristics of the Cold-Rolling Texture in a Multi-Layered Material Composed of SUS301 and SUS420J2 Steels
- 低炭素鋼の種々の微細組織における脆性破壊支配因子としての有効結晶粒径
- Ferrite Grain Size Formed by Large Strain-High Z Deformation in a 0.15C Steel
- Effect of Nano-Scale Copper Sulfide Precipitation on Mechanical Properties and Microstructure of Rapidly Solidified Steel with Tramp Copper Element
- The fiber components in the biaxially warm-deformed low-carbon steels
- Analysis of the dislocation structure in warm - deformed steels by the modified Warren - Averbach X - ray profile method
- Effect of Manganese Segregation on Fine-grained Ferrite Structure in Low-carbon Steel Slabs
- Improvement of strength-and-toughness balance of recycled steel through ultrarefinement of grain size
- オーステナイト粒径とひずみを変化させたときのフェライト粒組織 〜 再加熱鋳造材の場合 〜
- オーステナイト粒径とひずみを変化させたときのフェライト粒組織 - 再加熱鋳造材の場合 -
- Effect of Annealing on Tensile Properties of Ultrafine-Grained Steels Fabricated by Grooved Warm Rolling
- In-situ Observation of Intragranular Ferrite Nucleation at Oxide Particles
- Serration of Grain Boundary in Ni-30Fe Alloy through High Temperature Deformation
- Dynamic Restoration Process of Ni-30Fe alloy during Hot Deformation
- 温間多方向加工によって形成される微細フェライト粒組織
- Effect of Shear Deformation of Development of Fine-grained Ferrite Structures
- Microstructural Design through Multi-Direction Deformation
- Analysis on Refinement of Columnar γ Grain by Phosphorus in Continuously Cast 0.1mass% Carbon Steel
- Influence of Phosphorus on Solidification Structure in Continuously Cast 0.1mass% Carbon Steel
- 低炭素鋼CC材の柱状γ粒におけるPによる微細化効果
- 高P含有低炭素鋼CC材の組織に及ぼす凝固モードの影響
- Structure of Continuously Cast Slab of High Phosphorus 0.1mass%C Steel
- Subsurface Crack Generation in High-cycle Fatigue for High Strength Alloys
- Dynamic Recrystallization of Ferrite during Large Strain Warm Compression Of Ultra-Low Carbon Steel
- Classification of Microstructural Evolution During Single Pass-Large Strain-High Z Deformation of a 0.15 C Steel
- Effect of Deformation Temperature and Strain Rate on Evolution of Ultrafine Grained Structure through Single-Pass Large-Strain Warm Deformation in a Low Carbon Steel
- Strain-hardening due to Dispersed Cementite for Low Carbon Ultrafine-grained Steels
- 低炭素鋼の高Z大歪加工における超微細粒組織の形成
- Dynamic Restoration Process of Ni-30Fe Alloy during Hot Deformation
- 温間圧延によって製造した超微細フェライト+セメンタイト組織鋼板の特性
- セメンタイト粒子分散による低炭素超微細粒鋼のひずみ硬化設計
- オーステナイト粒径とひずみを変化させたときのフェライト粒組織 〜再加熱鋳造材の場合〜
- Strength - Ductility Balance of the Ultrafine - grained Ferrite and Cementite Structure
- Effect of Warm Deformation Temperature on Formation of Ultrafine - grained Ferrite Structure for a Low Carbon Si - Mn Steel
- Fine Ferrite Formation from Deformed Austenite with Different Grain Size
- Microstructural and Micro-textural Evolution during Single Pass High Z-large Strain Deformation of a 0.15C Steel
- Prediction on Nominal Stress-Strain Curve of Isotropic Polycrystal Ti-15-3-3-3 Sheet by FE Analysis
- Continuously cast 0.1wt% C steels with high phosphorus : microstructural design and control
- Textures introduced by high-cross-angle cross rolling
- 高リン低炭素鋼ストリップ鋳片圧延材の機械的性質
- Effect of Diffusion of {100}Parallel to the ND Plane on the Charpy Impact Properties in Low Carbon Steels
- In-situ Observation of γ/α Phase Transformation in Low Carbon Steel by Laser Microscopy
- 高リン低炭素鋼のストリップ鋳片の特徴
- Continuously Cast 0.1 mass pct. C Steele with High Phosphorus: Microstructural Design and Control
- Continuously Cast 0.1 mass pct. C Steels with High Phosphorus : Microstructural Design and Control
- Continuously Cast 0.1 mass pct. C Steels with High Phosphorus: Microstructural Design and Control
- Improved Strength - and - Toughness Balance of P - added Low Carbon Steel through Ultrarefinement of Ferrite Grain Size
- Strength and Toughness Balance of Ultrafine - Grained Low Carbon Steel
- Structure of rapid solidification sheet in high P low carbon steel
- Evaluation of Plastic Deformation Limit by Circumferentially Notched Tension Test
- Ultrafine Grain Structure through Dynamic Recrystallization for Type 304 Stainless Steel
- Evolution of Columnar γ Grain in Low Carbon Steel and Its Refinement by Additional Elements in Thin Slab Casting Simulator
- Nucleation of Acicular Ferrite on Sulfide Inclusion during Rapid Solidification of Low Carbon Steel
- Interaction between Phosphorus Micro-Segregation and Sulfide Precipitation in Rapidly Solidified Steel-Utilization of Impurity Elements in Scrap Steel
- EBSD Characterization of the Twinning Microstructure in a High-Damping Mn-Cu Alloy
- The Twinning Microstructure and Damping Behavior in Mn-30Cu (at%) Alloy
- Influence of Phosphorus Micro-Segregation on Ferrite Structure in Cast Strips of 0.1mass% C Steel
- Novel processing recyclable and high performance steel bar
- Flow Stress Analysis using the Kocks-Mecking Model for Ferrite-Cementite Steels with Various Ferrite Grain Sizes
- High-speed Deformation for an Ultrafine-grained Ferrite-Pearlite Steel
- Effects of Cu on Diffusional Transformation Behavior and Microstructure in Fe-Mn-Si-C Steels
- Prediction on Nominal Stress-Strain Curve of Anisotropic Polycrystal with Texture by FE Analysis
- Effects of High Magnetic Field and Tensile Stress on Martensitic Transformation Behavior and Microstructure at 4.2K in Fe-Ni-C Alloys
- Microstructure of Cast Strip in 0.1mass%C Steels Containing Phosphorus
- Effect of Strain on Ultrafine Ferrite Grains formed by Single-Pass Large Strain-High Z Deformation
- A trical to fabricate a 25mm - thick plate with ultrafine - grained ferrite structure
- Strain Rate Dependence of Stress-Strain Curves in a Ti-Fe-O Alloy
- Evolution of Fine Ferrite Structure in Continuously Cast 0.1mass%C steel with 100mm-thickness
- Fatigue Properties of Titanium Alloys in Liquid Helium
- Prediction of Nominal Stress-Strain Curves of a Multi-Layered Composite Material by FE Analysis
- SA-08-1(024) Time dependent flow behavior of pure aluminum and aluminum-magnesium alloy under a constant stress condition(Flaw Progress & Failure Mechanism 1)
- 超微細フェライト粒組織形成におけるオーステナイト粒径の重要度
- The Damping Behavior of Ni Added Mn-Cu Damping Alloys
- Luders Deformation in Submicron-grained Ferrite steels
- True Stress-True Strain Relations with Very Low Strain Rates at Room Temperature for an Austenitic 25Cr-19Ni Steel
- Toughness of ultrafine - grained ferrite steel plate fabricated by cross - roll rolling
- Ultrafine grain structure through dynamic recrystallization for SUS 304 stainless steel
- 超細粒鋼の被削性について
- Description of Stress-strain Curves Based on Thermal Activation Models for a Ti-Fe-0 Alloy at 77 to 296 K with Strain Rates from 10^ to 10^sec^
- Numerical analysis of deformation behavior for over-matched weld joints
- Neutron diffraction study on work-hardening of a fine-grained ferrite-pearlite steel
- Effect of Temperature on Stress - Strain Curve for Ultrafine - Grained Steels
- Influence of Interstitial Content on Low Temperature Fatigue Fracture (High - cycle Fatigue Behavior of Extra - low Carbon Steel - 1)
- Distribution of Internal Crack Initiation Sites in High-cycle Fatigue for Titanium Alloys
- Ultra-steel : Fabrication Makes New Material Structure(Synergy by Microstructuring)
- 超微細粒鋼の展望と課題-STX-21を例として-
- パンキーキγ粒厚さと生成する粒界α厚さの関係
- 大ひずみ加工下で均一・微細フェライト粒組織形成に必要なひずみ
- 超微細フェライト粒組織形成におけるオーステナイト粒径の重要度
- 超微細フェライト粒組織形成におけるオーステナイト粒径の重要度
- Internal crack initiation in high-cycle fatigue of a Ti-Fe-O alloy at liquid nitrogen temperature
- Hot extrusion for Al-Si-(Fe, Cu) hyper-eutectic cast alloys
- Cryogenic mechanical properties of Ti-6Al-4V alloys with three levels of oxygen content
- Internal crack initiation in high cycle fatigue of Ti-6Al-4V alloys at cryogenic temperatures
- Prediction of Prior Austenite Grain Size of High-phosphorous Steels through Phase Transformation Simulation
- Public Research Institutes for High-Performance Steels in China
- 変形γから生成するフェライトの大きさを支配するパンケーキγの厚さ
- Concepts and attempts for ULTRA STEELs at NIMS
- Utilization of Impurities for Ultrafine Grain Steels