Sensitivity Correction Control of the Ultrasonic Sensor due to Doppler Shift
スポンサーリンク
概要
- 論文の詳細を見る
Authors propose the use of an ultrasonic transducer to achieve a passive safety system for a collision using a corner sensor. However, the sensitivity of the transducer decreases owing to Doppler shift in the case of a travelling car. On the contrary, authors also propose a resonance control method for the transducer using a generalized impedance converter (GIC) circuit. In this study, the resonance control frequency method is used to correct the sensitivity of the transducer. In the sensitivity control, the input impedance control of the GIC circuit is tried using a voltage-controlled resistance. The automatic sensitivity correction control is expected to be realized by a combination of the GIC circuit and frequency–voltage (F/V) converter. As a result, the sensitivity of a Langevin transducer with a GIC circuit as a receiver is slightly improved, compared with that of a retailed transducer. Moreover, the resonance frequency of the transducer can be controlled in the range of about 3 kHz using the GIC circuit and F/V converter.
- 2008-05-25
著者
-
Aizawa Shin-ichi
Faculty of Engineering, Shibaura Institute of Technology, 3-7-5 Toyosu, Kotoh-ku, Tokyo 135-8548, Japan
-
Koike Yoshikazu
Faculty of Engineering, Shibaura Institute of Technology, 3-7-5 Toyosu, Kotoh-ku, Tokyo 135-8548, Japan
-
Koike Yoshikazu
Faculty of Engineering, Shibaura Institute of Technology, 3-7-5 Toyosu, Koto, Tokyo 135-8548, Japan
関連論文
- Application of novel ultrasonic cleaning equipment that uses the waveguide mode for the single-wafer cleaning process (Special issue: Advanced metallization for ULSI applications)
- Novel Ultrasonic Cleaning Equipment Using Waveguide Mode
- Application of Novel Ultrasonic Cleaning Equipment Using Waveguide mode for Post-Chemical-Mechanical-Planarization Cleaning
- Sensitivity Correction Control of the Ultrasonic Sensor due to Doppler Shift