掩蔽作用に関する分析化学的研究-5・6-
スポンサーリンク
概要
- 論文の詳細を見る
Fundamental requirements for masking Al<SUP>3+</SUP> and Ti<SUP>4+</SUP> in an alkaline solution of sulfosalicylic acid and the separation of each ion from the masking solution have been investigated. A satisfactory result was obtained by boiling a masking solution of pH above 9.4 to hydrolyze, Ti<SUP>4+</SUP>, and then recovering the Ti<SUP>4+</SUP> as TiO<SUB>2</SUB>.2H<SUB>2</SUB>O and the Al<SUP>3+</SUP> in the filtrate as an oxinate. In the case of a large amount of Ti<SUP>4+</SUP> as compared with Al<SUP>3+</SUP>, it was necessary to repeat the hydrolysis of Ti<SUP>4+</SUP>. In the separation of Ti<SUP>4+</SUP> and Fe<SUP>3+</SUP> by the use of sulfosalicylic acid, masking of these ions was effected by the use of alkaline sulfosalicylic acid, solution, and the difference in the propensity for forming complex salt possessed by these ions was utilized for their analysis. A satisfactory result was obtained by treating the masking solution with (NH<SUB>4</SUB>) <SUB>2</SUB>S for separating and recovering Fe<SUP>3+</SUP> as an iron sulfide, and then by boiling the filtrate containing Ti<SUP>4+</SUP> complex salt for the separation of Ti<SUP>4+</SUP>. In the case of a large amount of Ti<SUP>4+</SUP> as compared with Fe<SUP>3+</SUP>, good results were obtained by reprecipitation.<BR>Separation of Al<SUP>3+</SUP> and Fe<SUP>3+</SUP> masked by the use of an alkaline solution of sulfosalicylic acid has been investigated, and good results were obtained by treating the solution with (NH<SUB>4</SUB>)<SUB>2</SUB>S for separating and recovering Fe<SUP>3+</SUP> as iron sulfide. The Al<SUP>3+</SUP> in the filtrate was then separated as an oxinate. In the case of a large amount of Fe<SUP>3+</SUP> as compared with Al<SUP>3+</SUP>, good results were obtained by reprecipitation. Also, it was found that the presence of S<SUP>2-</SUP> had no effect on the separation of Al<SUP>3+</SUP> by the oxin method. In the separation of Mg<SUP>2+</SUP> and Al<SUP>3+</SUP> on an alkaline masking solution, the oxin method was applied to the masking solution of sulfosalicylic acid. The masking solution was made weakly acid, Al <SUP>3+</SUP> was precipitated as an oxinate, and Mg ixinate was recovered from the filtrate. The amount of sulfosalicylic acid used in this separation had no relation to the percentage recovery of these ions. The phosphate method was also tested for the separation, but the result was not satisfactory.
- 社団法人 日本分析化学会の論文
著者
関連論文
- 掩蔽作用に関する分析化学的研究(第3〜4報)
- スルホサリチル酸によるAl3+,Fe3+およびTi4+の掩蔽作用について : 掩蔽作用に関する分析化学的研究(第1報)
- 掩蔽作用に関する分析化学的研究-5・6-
- 掩蔽作用に関する分析化学的研究-7-
- The Masking of Mn2+, Mg2+ and Cu2+ by Means of Sulfosalicylic Acid:Analytical Studies on Masking Reactions. II