Chemical composition of crud depositing on BWR fuel surfaces.
スポンサーリンク
概要
- 論文の詳細を見る
Deposition profiles of corrosion products on fuel surfaces and products chemical compositions were determined at Shimane Nuclear Power Plant, a low-crud BWR. The deposited amounts were expressed as functions of crud concentration in the reactor water, fuel burnup and flow velocity in a fuel channel. The results could be predicted satisfactorily by the crud deposition model based on microlayer evaporation and drying out phenomena. The amount depositing at high flow velocity gave saturated values which were inversely proportional to the flow velocity (∝1/v), while those at low velocity did not reach saturated values, but rather were proportional to 1/v<SUP>3</SUP>. The depositing corrosion products could be divided into two layers, inner and outer, with more Co ions being taken into the former layer.
- 一般社団法人 日本原子力学会の論文
著者
-
Uchida Shunsuke
Energy Research Laboratory Hitachi Ltd.
-
Ohsumi Katsumi
Hitachi Works Hitachi Ltd.
-
Asakura Yamato
Energy Research Laboratory Hitachi Ltd.
-
Aizawa Motohiro
Hitachi Engineering Co. Ltd.
-
MIKI Minoru
Hitachi Works, Hitachi, Ltd.
-
YONEZAWA Koichi
Chugoku Electric Power Co.
-
MATSUSHIMA Yasunori
Chugoku Electric Power Co.
-
AIZAWA Motohiro
Hitachi Engineering Co.
関連論文
- Evaluation Methods for Corrosion Damage of Components in Cooling Systems of Nuclear Power Plants by Coupling Analysis of Corrosion and Flow Dynamics (IV) : Comparison of Wall Thinning Rates Calculated with the Coupled Model of Static Electrochemical Analy
- Evaluation Methods for Corrosion Damage of Components in Cooling Systems of Nuclear Power Plants by Coupling Analysis of Corrosion and Flow Dynamics (III) : Evaluation of Wall Thinning Rate with the Coupled Model of Static Electrochemical Analysis and Dyn
- Evaluation Methods for Corrosion Damage of Components in Cooling Systems of Nuclear Power Plants by Coupling Analysis of Corrosion and Flow Dynamics (II) : Evaluation of Corrosive Conditions in PWR Secondary Cooling System
- Evaluation Methods for Corrosion Damage of Components in Cooling Systems of Nuclear Power Plants by Coupling Analysis of Corrosion and Flow Dynamics (I) : Major Targets and Development Strategies of the Evaluation Methods
- Application of In-Service Temperature Lowering to Reduce Radioactivity Corrosion Product Deposition on Carbon Steel Piping of BWR Residual Heat Removal System
- Effects of Hydrogen Peroxide on Corrosion of Stainless Steel, (IV) : Determination of Oxide Film Properties with Multilateral Surface Analyses
- Effects of Hydrogen Peroxide on Corrosion of Stainless Steel, (III) : Evaluation of Electric Resistance of Oxide Film by Equivalent Circuit Analysis for Frequency Dependent Complex Impedances
- Effects of Hydrogen Peroxide on Corrosion of Stainless Steel, (II) : Evaluation of Oxide Film Properties by Complex Impedance Measurement
- Effects of Hydrogen Peroxide on Corrosion of Stainless Steel, (I) : Improved Control of Hydrogen Peroxide Remaining in a High Temperature High Pressure Hydrogen Peroxide Loop
- Water Chemistry in a Crack Tip under Irradiation, (I) Evaluation of Gamma-ray Energy Deposition in a Crack Tip
- Effects of Hydrogen Peroxide on Intergranular Stress Corrosion Cracking of Stainless Steel in High Temperature Water, (IV) Effects of Oxide Film on Electrochemical Corrosion Potential
- Effects of Hydrogen Peroxide on Intergranular Stress Corrosion Cracking of Stainless Steel in High Temperature Water, (III)Crack Growth Rates in Corrosive Environment Determined by Hydrogen Peroxide
- Effcts of Hydrogen Peroxide on Intergranular Stress Corrosion Cracking of Stainless Steel in High Temperature Water, ( II ) Optimization of Crack Propagation Rate Measurement System
- Study of Polarization Curve Measurement Method for Type 304 Stainless Steel in BWR High Temperature-High Purity Water
- Hydrogen and Hydrazine Co-injection to Mitigate Stress Corrosion Cracking of Structural Materials in Boiling Water Reactors, (VI) The Effect of Ammonia on Intergranular Stress Corrosion Cracking
- Hydrazine and Hydrogen Coinjection to Mitigate Stress Corrosion Cracking of Structural Materials in Boiling Water Reactors (VII) : Effects of Bulk Water Chemistry on ECP Distribution inside a Crack
- Hydrazine and Hydrogen Co-injection to Mitigate Stress Corrosion Cracking of Structural Materials in Boiling Water Reactors (IV) : Reaction Mechanism and Plant Feasibility Analysis
- Effects of Hydrogen Peroxide on Corrosion of Stainless Steel (VI) : Effects of Hydrogen Peroxide and Oxygen on Anodic Polarization Properties of Stainless Steel in High Temperature Pure Water
- Effects of Hydrogen Peroxide on Corrosion of Stainless Steel, (V) Characterization of Oxide Film with Multilateral Surface Analyses
- Effects of Hydrogen Peroxide on Intergranular Stress Corrosion Cracking of Stainless Steel in High Temperature Water, (V) : Characterization of Oxide Film on Stainless Steel by Multilateral Surface Analyses
- Mitigation Effect of Alkaline Water Chemistry upon Intergranular Stress Corrosion Cracking of Sensitized 304 Stainless Steel
- Effects of Hydrogen Peroxide on Cobalt Deposition Rate on Primary Cooling System of Boiling Water Reactors
- Effects of Hydrogen Peroxide on Radioactive Cobalt Deposition on Stainless Steel Surface in High Temperature Water
- Determination of Hydrogen Peroxide in Water by Chemiluminescence Detection, (I) : Flow Injection Type Hydrogen Peroxide Detection System
- Determination of Hydrogen Peroxide in Water by Chemiluminescence Detection, (II) : Theoretical Analysis of Luminol Chemiluminescence Processes
- Water Chemistry in a Crack Tip under Irradiation, (II) Evaluation of Oxidant Concentration in the Crack Tip
- Water Chemistry Data Acquisition, Processing, Evaluation and Diagnostic Systems in Light Water Reactors
- Evaluation of Effectiveness of Hydrogen Water Chemistry for Different Types of Boiling Water Reactors
- Empirical Understanding of the Dependency of Hydrogen Water Chemistry Effectiveness on BWR Designs
- The Luminescence from a Long Lasting Phosphor Exposed to Alpha, Beta, and Gamma Rays
- Effects of Hydrogen Peroxide on Intergranular Stress Corrosion Cracking of Stainless Steel in High Temperature Water, (I), Effects of Hydrogen Peroxide on Electrochemical Corrosion Potential of Stainless Steel
- Evaluation Methods for Corrosion Damage of Components in Cooling Systems of Nuclear Power Plants by Coupling Analysis of Corrosion and Flow Dynamics (V) Flow-Accelerated Corrosion under Single- and Two-phase Flow Conditions
- Effects of Organic Impurities on BWR Water Chemistry, (2) Effects on Shutdown Dose Rate
- Evaluation of Leachable Behavior from Ion Exchange Resins Effects of Organic Impurities on BWR Water Chemistry, (1)
- A Mechanism for Corrosion Product Deposition on the Carbon Steel Piping in the Residual Heat Removal System of BWRs
- Low Corrosive Chemical Decontamination Method Using pH Control, (II) Decomposition of Reducing Agent by Using Catalyst with Hydrogen Peroxide
- Noncontact Measurement of Film Thickness by the Photothermal Deflection Method
- Adsorption of Cobalt Ions on Hematite Particles
- Hydrazine and Hydrogen Coinjection to Mitigate Stress Corrosion Cracking of Structural Materials in Boiling Water Reactors (VII) : Effects of Bulk Water Chemistry on ECP Distribution inside a Crack
- Structural Material Anomaly Detection System Using Water Chemistry Data, (VIII). Water Chemistry Simulator and Its Application to Resin Intrusion.:Water Chemistry Simulator and Its Application to Resin Intrusion
- Structural Material Anomaly Detection SystemUsing Water Chemistry Data, (VII). Diagnosing Causes of Small Changes in Water Chemistryby Analyzing On-Line Conductivity and pH Data.:Diagnosing Causes of Small Changes in Water Chemistry by Analyzing On-Line C
- Chemical state and deposition rate of nickel ion deposit produced on heated surface in high pressure boiling water.
- Radiolytic environments in boiling water reactor cores.
- Structural material anomaly detection system using water chemistry data. II Prediction model of dose rate around recirculation pipes in iron crud suppressed BWR.:Prediction Model of Dose Rate around Recirculation Pipes in Iron Crud Suppressed BWR
- Water quality control at primary cooling system of crud concentration suppressed boiling water reactor. II Evaluation of cobalt-58 behavior in iron crud suppressed BWR.:Evaluation of Cobalt-58 Behavior in Iron Crud Suppressed BWR
- Experimental evaluation of improved dual temperature hydrogen isotopic exchange reaction system.
- Chemical composition of crud depositing on BWR fuel surfaces.
- Structural material anomaly detection system using water chemistry data. (III). In-line monitors for electrical conductivity of high temperature water.:In-Line Monitors for Electrical Conductivity of High Temperature Water
- Experimental Evaluation of Release Rates of Cobalt Ions from Cobalt Oxides at 285°C
- Hydrolytic desulfonation of cation exchange resins in high temperature water.
- Numerical analysis of hydrogen isotope separation characteristics in improved dual temperature exchange reaction system between water and hydrogen gas.
- BWR plants with low shutdown radiation level. Design and construction of plants and current experience with occupational exposure of plants.:Design and Construction of Plants and Current Experience with Occupational Exposure of Plants
- Pressure balanced type membrane covered polarographic oxygen detector for use in high temperature-high pressure water.
- Pressure balanced type membrane covered polarographic oxygen detectors for use in high temperature-high pressure water, (I) Application of guard electrode to improve detector performance at temperatures above 200.DEG.C.:Application of Guard Electrode to I
- Effects of crud diameter on shutdown dose rate of recirculation pipes in boiling water reactors.
- Water quality control in primary cooling system of crud concentration suppressed boiling water reactor. I Water chemistry experience in latest crud conentration suppressed BWR.:Water Chemistry Experience in Latest Crud Conentration Suppressed BWR
- Stability of catalytic activity in platinum impregnated porous teflon.
- Structural material anomaly detection system using water chemistry data. (I) Basic structure of anomaly detection system and its application for fuel defect detection.:Basic Structure of Anomaly Detection System and Its Application for Fuel Defect Detecti
- Temperature dependence of cobalt release rate from stainless steel in neutral water.
- Estimation of shutdown dose rate around recirculation pipes during operating life of boiling wate reactors.