Gibbs energies of formation of TiS and Ti4C2S2 in austenite.
スポンサーリンク
概要
- 論文の詳細を見る
The Gibbs energies of formation of TiS and Ti4C2S2 from Ti, S and C solutes in austenite are evaluated on the basis of the solubility data measured by Swisher in the Fe-C-S-Ti system. These quantities are employed in equilibrium calculations applied to a series of Ti bearing steels. The results indicate that Ti4C2S2 is expected to predominate in Ti microalloyed steels, whereas both TiS and Ti4C2S2 are likely to be present in Ti modified extra-low-carbon IF steels. These predictions are in good agreement with the experimental observations reported by other researchers.
- The Iron and Steel Institute of Japanの論文
著者
-
Jonas J.
Department Of Materials Engineering Mcgill University
-
JONAS J.
Department of Metallurgical Engineering, McGill University
-
Liu W.
Center for Metallurgical Process Engineering, University of British Columbia
-
Bouchard D.
CRCT, Centre for Research in Computational Thermochemistry, Ecole Polytechnique de Montreal
-
Bale C.
CRCT, Centre for Research in Computational Thermochemistry, Ecole Polytechnique de Montreal
関連論文
- Mathematical Modeling of Mean Flow Stress during the Hot Strip Rolling of Nb Steels
- Mathematical Modeling of the Mean Flow Stress, Fractional Softening and Grain Size during the Hot Strip Rolling of C-Mn Steels
- Influence of Ferrite Rolling Temperature on Microstructure and Texture in Deformed Low C and IF Steels
- TEM Characterization of the Recrystallization Behaviour of Warm Rolled Low Carbon Steels Containing Chromium during the Early Stages of Annealing
- Influence of Ferrite Rolling Temperature on Grain Size and Texture in Annealed Low C and IF Steels
- Mathematical Modelling of Mean Flow Stress during the Hot Strip Rolling of Multiply-alloyed Medium Carbon Steels
- Distinctive Aspects of the Physical Metallurgy of Warm Rolling
- Prediction of Interpass Softening from the Strain Hardening Rate Prior to Unloading
- Modelling Texture Change during the Static Recrystallization of a Cold Rolled and Annealed Ultra Low Carbon Steel Previously Warm Rolled in the Ferrite Region
- Dynamic Strain Aging and the Wire Drawing of Low Carbon Steel Rods
- Spreadsheet Modelling of Grain Size Evolution during Rod Rolling
- Kinetics and Critical Conditions for the Initiation of Dynamic Recrystallization in 304 Stainless Steel
- FEM Simulation of Deep Drawing of Textured Aluminum Sheets Using Anisotropic Fourth-Order Strain-Tate Potential
- Static and Dynamic Strain Aging at High Temperatures in 304 Stainless Steel
- Effect of Silicon on the Interaction between Recrystallization and Precipitationin Niobium Microalloyed Steels
- Effect of Initial Grain Size on the Static Recrystallization Kinetics of Nb Microalloyed Steels
- Static Recrystallization of Nb and Nb-B Steels under Continuous Cooling Conditions
- Ultrasonic Prediction of r-value in Deep Drawing Steels.
- Gibbs energies of formation of TiS and Ti4C2S2 in austenite.
- Effect of Controlled Rolling on Texture Development in a Plain Carbon and a Nb Microalloyed Steel.
- Influence of Dynamic Recrystallisation on the Tensile Ductility of Steels in the Temperature Range 700 to 1150.DEG.C..