High-Frequency Low-Noise Voltage-Controlled LC-Tank Oscillators Using a Tunable Inductor Technique(<Special Section>Novel Device Architectures and System Integration Technologies)
スポンサーリンク
概要
- 論文の詳細を見る
This paper describes 3-GHz and 7-GHz tunable-inductance LC-tank voltage-controlled oscillators (VCOs) implemented in 0.18-μm CMOS technology. Unlike the traditional tuning method by a varactor, a tunable inductor is employed in the VCO by using a transformer to compensate for the energy loss. The VCO facilitates the tuning frequency and low noise of the output signals, together with a variable inductor which satisfies both criteria. The 3-GHz VCO using a symmetry transformer provides the tuning range of 2.85 to 3.12GHz at 1-V supply. The power consumption is 4.8mW while the measured phase noise is -126dBc/Hz at 1-MHz offset from a 2.85-GHz carrier. A small-area stacked transformer is employed in the 7-GHz VCO, which achieves a tuning range of 6.59 to 7.02GHz and measured phase noise of -114dBc/Hz at 1-MHz offset from a 6.59-GHz carrier while consuming 9mW from a 1.2-V supply.
- 社団法人電子情報通信学会の論文
- 2006-11-01
著者
-
Yang Ching-yuan
Department Of Electrical Engineering National Chung Hsing University
-
Tsai Meng-ting
Department Of Electrical Engineering National Chung Hsing University
関連論文
- A 1.25-Gb/s Burst-Mode Half-Rate Clock and Data Recovery Circuit Using Realigned Oscillation(Electronic Circuits)
- A 3.2-GHz Down-Spread Spectrum Clock Generator Using a Nested Fractional Topology
- Injection-Locked Clock Recovery Using a Multiplexed Oscillator for Half-Rate Data-Recovered Applications
- A 1V CMOS Dynamic Back-Gate Forward Bias Prescaler for Frequency Synthesizer Application
- High-Frequency Low-Noise Voltage-Controlled LC-Tank Oscillators Using a Tunable Inductor Technique(Novel Device Architectures and System Integration Technologies)