搬送用ローラーにおけるセラミックス製スリーブの焼嵌め接合部に生じる最大応力について

概要

論文の詳細を見る
Steel conveying rollers used in hot rolling mills must be changed very frequently at great cost because hot conveyed strips induce wear on the roller surface in short periods. In this study new roller structure is considered where a ceramics sleeve is connected with two short shafts at both ends by shrink fitting. Here, ceramics sleeve may provide longer life and reduce the cost for the maintenance. However, care should be taken for the maximum tensile stress between the sleeve and shafts because the fracture toughness of ceramics is extremely lower than the values of steel. In this study FEM analysis is applied to the structure, and the maximum tensile stress has been investigated with varying the dimensions of the structure. It is found that the maximum tensile stress appearing at the end of sleeve takes a minimum value at a certain amount of shrink fitting ratio.
2008-07-25