前面すみ肉溶接継手の変形挙動と強度に関する研究

概要

論文の詳細を見る
In the previous paper, theoretical evaluation on the strength of fillet welded joint was presented and compared with the experimental results. Theoretical value agreed well with the test results obtained by using model specimens machined from a homogeneous mild steel sheet. But in the welded joints, mechanical properties of weld metal and heat-affected zone are different from those of base metal. So the mechanical behaviour and the strength of fillet welded joint will be different from those of model specimen. In this paper the mechanical behaviour and the strength of the front fillet welded joints are explained experimentally and theoretically. Experiments are made with four typical types of front fillet welded joints as follows; 1. Double Tee fillet welded joint. 2. Double strapped fillet welded joint. 3. Double Tee fillet welded joint including soft or hard weld metal. 4. Partial penetration groove welded joint. The results obtained are as follows. 1. Fracture mode of fillet weld is affected by the strength and work hardening properties of weld metal (cf. Photo 1). 2. The strength of front fillet welded joint can be calculated by using the equation (2), (3), or (4) which are given by theoretical analysis. 3. The strength of front fillet welded joint including soft or hard weld metal can be estimated by using the equivalent weld metal strength σ_<we> (cf. Fig. 15). 4. The friction between base plate and strapped plate has large influence on the strength of double strapped fillet welded joint (cf. Fig. 11,Fig. 12). 5. The equation for evaluation of the strength of partial penetration groove welded joint is given by comparing the test results and the theoretical analysis.
社団法人溶接学会の論文
1972-10-25

前面すみ肉溶接継手の変形挙動と強度に関する研究

スポンサーリンク

概要

著者

関連論文

スポンサーリンク