The Reheated Zone Toughness of Multipass Weld Metal (Report 1) : Comparison of Reheated Zone Toughness between Si-Mn System and High Strength Low Alloy System Weld Metals

スポンサーリンク

概要

• 論文の詳細を見る
• 社団法人溶接学会の論文
• 1983-04-01

著者

• Araki T

  Ehime Univ.

• YONEDA Masafumi

  Faculty of Engineering Osaka University

• Araki T

  Department Of Materials Science And Engineering Ehime University

• Kikuta Y

  Osaka University

• Kikuta Yoneo

  Faculty Of Engineering Osaka University

関連論文

• Contraction Process and RRC Test of Nodular Graphite Cast Iron Weldments : Studies on the Weld Cracking of Nodular Graphite Cast Iron (Report 5)
• Preheating Effect on the Critical Rupture Stress of Nodular Graphite Cast Iron Welds : Study on the Weld Cracking of Nodular Graphite Cast Iron (Report 2)
• Techniques to separate metal from waste printed circuit boards from discarded personal computers
• Improvement of temperature coefficient of capacitance in Y5V film capacitor prepared by pulsed laser deposition (特集 [日本材料科学会]支部特集(四国地区))
• Pulverization of waste printed circuit boards
• Formation of Droplets on Thin Film Surface in Pulsed Laser Deposition Using Metal Targets
• Metallurgical Study on the HAZ Embrittlement of High Strength Steel (Report 1) : Application of the Quantitative Chemical Analysis for Precipitates to Steel and its Welds
• Contribution of Cementites to Notch Toughness in Structural Steel Welds
• Effect of Nonmetallic Inclusions on Hydrogen Assisted Cracking
• Effect of Hot Strain Embrittlement on Cold Crack Sensitivity in Steel Welding
• The Effect of Center Segregation of TMCP Steels with Continuous Casting Process on Weld Cold Cracking
• The Development of BaTiO3 Thin Films for Multi Layer Ceramic Capacitor by Pulsed Laser Deposition
• Effect of Some Parameters on Microcrackings in the Fillet Weld between the Lowest Course Shell Plate and the Annular Plate in Oil Strage Tank
• Prevention of Hydrogen-Induced Disbonding for Austenitic Stainless Overlay Weld Metal
• Hydrogen-Induced Disbonding for Austenitic Stainless Overlay Weld Metal Exposed to Elevated Temperature under High Pressure Hydrogen Atrnosphere
• The Reheated Zone Toughness of Multipass Weld Metal (Report 1) : Comparison of Reheated Zone Toughness between Si-Mn System and High Strength Low Alloy System Weld Metals
• Ductility Loss due to Dynamic Strain Aging in Heat-Affected Zone of High Strength Low Alloy Steel

もっと見る 閉じる

スポンサーリンク