DTM : Dynamic Transfer Mode Based on Dynamically Assigned Short-Hold Time-Slot Relay

概要

論文の詳細を見る
This paper proposes a new high-speed network architecture called Dynamic Transfer Mode, DTM. At the entrance of the DTM network, destination addresses such as IP addresses are converted into DTM routing informatian and attached to the packet header. In a DTM network, a connection is set up on-the-fly by sending a series of routing link identifiers to the destination, so burst data transfers like WWW trafic are efficiently carried. A connection between adjacent nodes is created and released dynamically within the burst transfer period. This yields higher statistical multiplexing gain and improved band-width efficiency compared to with conventional STM. Time division multiplexing is utilizcd so delay jitter or cell loss, the major drawbacks of Asynchronous Transfer Mode, are avoided. This paper analyzes the performance of a DTM network and describes an implemented switching system. Because a DTM network uses source-routing and passive STM switching, it simplifies the core transit switch while localizing intelligence to edge nodes. A simplified core transit switch is well suited for future high-speed backbone networks.
社団法人電子情報通信学会の論文
1999-02-25