多孔板を用いた整流装置の研究 : 第2報,流量計測における整流装置の効果

概要

論文の詳細を見る
In metering the flow rate of fluid in a pipe line, it is most important that the flow approaches the orifice flowmeter in a normally turbulent state. When the approach piping of an orifice flowmeter is shorter than that recommended by the JIS Z 8762, it leads to noticeable error. So, the rectifying device investigated in the first report was tasted for reducing error. This device was installed just behind the single, double, and triple bends. The effects of bent pipes on the discharge coefficient of orifice flowmeter were examined experimentally. It was found that this device could reduce the minimum required lengths of straight pipe on the inlet side of the orifice flowmeter to a large extent without sacrificing its accuracy.
一般社団法人日本機械学会の論文
1986-05-25