冷間型鍛造によるクラッド歯車成形 : 材料型孔内充てんの定量的評価(機械要素,潤滑,工作,生産管理など)

概要

論文の詳細を見る
The relief hole-type divided metal flow die forging process was adopted to fabricate the clad gear in this research. The influence of the deformation condition on the surface pressure and the metal filling into the die cavity were quantitatively evaluated. The purpose in the study is to obtain the optimum deformation condition from the viewpoint of reducing the surface pressure. In the experimental simulation of the die forging, an industrial pure aluminum was employed both for the inner layer material and for the outer layer material of the clad gear. The "2 step-type die forging process" and "Die forging process with mandrel" were adopted to realize the "divided metal flow state". As a result of the experiment, the following two points were clarified. (1) The filling performance of the "2 step-type" is higher by 20〜30% than that of "1 step-type" under the same pressure condition. (2) The pressure of "2 step-type die forging process" to perform the high metal filling into the die cavity is smaller than that of "Die forging process with mandrel". And the filling rate in the case of the mandrel projection height 4 mm is higher than that of 2 mm.
一般社団法人日本機械学会の論文
2002-05-25