Static Characteristics of 7/24 Tapered Joint for Machining Center : 1st Report, Effects of Taper Size and Angle Error
スポンサーリンク
概要
- 論文の詳細を見る
The static bending stiffness and the axial displacement of the 7/24 taper shank tool, which is used in the machining center, have been experimentally investigated. Mainly, the effects of the taper size and angle error were investigated, by changing the tensile force of a draw-in bolt. From the results, It was found that the bending stiffness is affected by the tensile force and the taper angle error. The axial displacements of the taper shank are affected by the taper angle error, but independent of the taper size. In addition, the similarity law of the static bending stiffness is precisely investigated. From the results, it was found that the inclination angle which is the most important factor is in inverse proportion to the second power of the scale factor.
- 一般社団法人日本機械学会の論文
著者
-
ANNO Yoshiro
Tokyo Institute of Technology
-
Tsutsumi Masaomi
Research Associate Tokyo Institute Of Technology
-
EBATA Nobuo
Mitsubishi Atomic Industry
関連論文
- An Analysis of the Elastic and Plastic Deformation of Machined Surfaces in Contact : 4th Report, Deformation of Contacting Rough Surfaces when Directional Asperities and Nondirectional Ones are in Contact
- An Analysis of the Elastic and Plastic Deformations of Machined Surfaces in Contact : 2nd Report, Comparison between Calculated and Experimental Results on the Deformations of Rough Surfaces in Contact
- An Analysis of the Elastic and Plastic Deformations of Machined Surfaces in Contact : 1st Report, Deformations of Contacting Rough Surfaces when the Directions of Surface Asperities Cross Each Other
- An Analysis of the Elastic and Plastic Deformations of Machined Surfaces in Contact : 3rd Report, On the Contact of Surfaces Whose Asperities do not have Directional Qualities
- An Analysis of the Deformation of Contacting Rough Surfaces : 3rd Report, Introduction of a New Contact Theory of Rough Surfaces
- An Analysis of the Deformation of Contacting Rough Surfaces : 4th Report. Formulae for Practical Use on Deformation of Plane Joints Making the Directions of Surface Asperities Parallel to Each Other
- Analysis and Synthesis of a Pressure Compensated Deceleration Valve
- The Discharge Coefficient of Spool Type Hydraulic Valve : 3rd Report, The Taper Land Spool Valve
- Static Characteristics of 7/24 Tapered Joint for Machining Center : 1st Report, Effects of Taper Size and Angle Error
- An Analysis of the Deformation of Contacting Rough Surfaces : 1st Report, Analysis and Measurement of Slope of Surface Roughness
- An Analysis of the Elastic and Plastic Deformations of Machined Surfaces in Contact : 5th Report, Formulae of Deformations of Plane Joints Machined by Various Methods for Practical Use