The Discharge Coefficient of Spool Type Hydraulic Valve : 3rd Report, The Taper Land Spool Valve
スポンサーリンク
概要
- 論文の詳細を見る
In this report, the discharge property of a taper land spool valve is analyzed theoretically on the assumption of laminar flow and verified experimentally. Theoretically, we assume a taper land channel as a two-dimensional divergent or convergent channel, and obtain a pressure loss with approximate velocity profile. In the inlet part, we apply the similarity of velocity profile to a boundary layer equation and obtain a pressure loss in the inlet length. Experimentally, we make a model of two-ports valve and obtain precise data. Taper angle is set to be 1.5°〜6°, spool displacement 0.5〜4 mm, Reynolds number 10〜1,200. In this range we experiment, and compute the discharge property in the same range. In the result, experiment data show good coincidence with computation result. Further, the influences of back pressure of the valve are also discussed.
- 一般社団法人日本機械学会の論文
著者
-
ANNO Yoshiro
Tokyo Institute of Technology
-
Akiyama Nobuyuki
Production Engineering Research Laboratory Hitachi Ltd.
-
Anno Yoshiro
Tokyo Institute Of Technology.
関連論文
- An Analysis of the Elastic and Plastic Deformation of Machined Surfaces in Contact : 4th Report, Deformation of Contacting Rough Surfaces when Directional Asperities and Nondirectional Ones are in Contact
- An Analysis of the Elastic and Plastic Deformations of Machined Surfaces in Contact : 2nd Report, Comparison between Calculated and Experimental Results on the Deformations of Rough Surfaces in Contact
- An Analysis of the Elastic and Plastic Deformations of Machined Surfaces in Contact : 1st Report, Deformations of Contacting Rough Surfaces when the Directions of Surface Asperities Cross Each Other
- An Analysis of the Elastic and Plastic Deformations of Machined Surfaces in Contact : 3rd Report, On the Contact of Surfaces Whose Asperities do not have Directional Qualities
- An Analysis of the Deformation of Contacting Rough Surfaces : 3rd Report, Introduction of a New Contact Theory of Rough Surfaces
- An Analysis of the Deformation of Contacting Rough Surfaces : 4th Report. Formulae for Practical Use on Deformation of Plane Joints Making the Directions of Surface Asperities Parallel to Each Other
- Particle Detection for Patterned Wafers Using Hybrid Optical-Digital Image Processing : Inspection and Testing
- Analysis and Synthesis of a Pressure Compensated Deceleration Valve
- The Discharge Coefficient of Spool Type Hydraulic Valve : 3rd Report, The Taper Land Spool Valve
- Static Characteristics of 7/24 Tapered Joint for Machining Center : 1st Report, Effects of Taper Size and Angle Error
- An Analysis of the Deformation of Contacting Rough Surfaces : 1st Report, Analysis and Measurement of Slope of Surface Roughness
- Particle Detection for Patterned Wafers Using Hybrid Optical-Digital Image Processing
- An Analysis of the Elastic and Plastic Deformations of Machined Surfaces in Contact : 5th Report, Formulae of Deformations of Plane Joints Machined by Various Methods for Practical Use