Chatter Vibrations of Machine Tool or Work with Directional Stiffness Inequality
スポンサーリンク
概要
- 論文の詳細を見る
The cutting limit of stability can be increased by using a boring bar with a non-circular cross section. This fact has been reported by J.Tlusty, L.K. Kuchma, and S.Kato-E.Marui. Among these analytical or experimental reports, there seems to be no coincidence in the most effective orientation angle between cutting edge and minimum direction of boring bar stiffness. In this paper, many factors affecting the cutting limit of stability, that is, cutting conditions, time lag of cutting force to chip thickness fluctuation, shaft rigidity, asymmetry of stiffness, natural frequency, damping coefficient and angular velocity of shaft are investigated. Consequently, it is verified that three reports above mentioned coincide with the special cases of certain factors combined. The obtained results in this paper may be applied no only to the vibrationproof problems of boring bar, planer-tool, shaper-tool, lathe-tool, but also to those of workpiece set on lathe spindle.
- 一般社団法人日本機械学会の論文
著者
-
OTA Hiroshi
Faculty of Engineering, Nagoya University
-
Kono Kazutoyo
Tokushima Technical College
-
Ota Hiroshi
Faculty Of Engineering Nagoya University
-
Ota Hiroshi
Faculty Of Engineering Gunma University
関連論文
- Regenerative Chatter Vibrations of Turning Workpieces : Two Degrees of Freedom and Their Stability Criteria
- On the Occurrence of Regenerative Chatter Vibrations : Vibration, Control Engineering, Engineering for Industry
- Influence of Unequal Pedestal Stiffness on the Instability Regions of a Rotating Asymmetric Shaft : 4th Report, Further Considerations of an Approximate Analysis
- On Elimination of the Unstable Region of the Major Critical Speed in a Rotating Shaft System Carrying an Unsymmetrical Rotor : Dynamical Effect of a Flexible Pedestal or Added Mass on the Shaft
- Oxidation Behavior and Caking Property of Coal under the Atmosphere at Low Oxygen Concentration
- Lateral Vibrations of a Rotating Shaft Driven by a Universal Joint : 2nd Report, Analyses and Experiments on Even Multiple Vibrations by Secondary Moment
- Experiments on Vibrations of a Hollow Rotor Partially Filled with Liquid
- Lateral-Torsional Coupled Vibrations of a Rotating Shaft Driven by a Universal Joint : Derivation of Equations of Motion and Asymptotic Analyses
- Lateral Vibrations of a Rotating Shaft Driven by a Universal Joint : 1st Report, Generation of Even Multiple Vibrations by Secondary Moment
- Lateral Vibrations of an Asymmetrical Shaft Driven by a Universal Joint : 3rd Report, Analyses and Experiments on Forced Vibrations of Horizontal Shaft Caused by Gravity
- Lateral Vibrations of a Rotating Shaft Driven by a Universal Joint : 3rd Report, Vibrations Caused by Frictions between a Cross-Pin and Yokes : Series C : Vibration, Control Engineering, Engineering for Industry
- Lateral Vibrations of an Asymmetrical Shaft Driven by a Universal Joint : 2nd Report, Generation Mechanism of Unstable Vibrations
- Unstable Vibrations Induced by Rotationally Unsymmetric Inertia and Stiffness Properties
- Chatter Vibrations of Machine Tool or Work with Directional Stiffness Inequality
- The Effect of a Flat Shaft on the Unstable Vibrations of the Shaft Carrying an Unsymmetrical Rotor
- Influence of Unequal Pedestal Stiffness on the Instability Regions of an Asymmetrical Rotor
- Influence of Unequal Pedestal Stiffness on the Instability Regions of a Rotating Asymmetric Shaft : 3rd Report, Mechanism for Occurrence of Two Types of Unstable Vibrations
- On the Shaft End Torque and the Forced Vibrations of an Asymmetrical Shaft Carrying an Asymmetrical Rotor
- Influence of Unegual Pedestal Stiffness on the Instability Regions of a Rotating Asymmetric Shaft : 2nd Report, Inclinational Vibrations with Effects of Gyroscopic Action
- On the Shaft End Torque and the Unstable Vibrations of an Asymmetrical Shaft Carrying an Asymmetrical Rotor
- Self-Excited Vibrations of Wire-Winding-Type Growing Apparatus for Silicon Single Crystals : Experimental Results and Considerations Relevant to Self-Excited Vibrations
- On the Vibrations of the Shaft Carrying an Asymmetrical Rotating Body
- Unstable Vibrations of the Shaft Carrying an Unsymmetrical Rotating Body : Vibrations Induced by Flexibility of Bearing Pedestals
- Elastic and Damping Properties of Journal Bearing : 1st Report, Stationary Properties of Oil Film Bearing by Finite Bearing Approximation
- On the Forced Vibrations of the Shaft Carrying an Unsymmetrical Rotor : Forced Vibrations Having the Circular Frequencies Differing from the Rotating Angular Velocity of the Shaft
- On the Forced Vibrations of the Shaft Carrying an Unsymmetrical Rotating Body : Response Curves of the Shaft at the Major Critical Speeds