Basic Stady on the Hydrostatic Guideways : 1st Report, Theoretical Analysis of the Motion of Table with a Single Recess
スポンサーリンク
概要
- 論文の詳細を見る
This paper presents an analysis of the dynamic behavior of hydrostatic guideways. The linearized non-dimensional equations for the table motion and the coefficients of the equations are presented. This analysis by means of transfer functions clarifies the effects of the dimensions of the talbe and the oil feed line system, and can be applied to designing of hydrostatic guideways.
- 一般社団法人日本機械学会の論文
著者
-
Masuko Masami
Tokyo Institute Of Technology
-
AOKI Hiroshi
Tokyo Institute of Technology
-
Nakahara Tsunamitsu
Tokyo Institute Of Technology
-
Aoki Hiroshi
Tokyo Institute Of Technology.
関連論文
- Research on Improvement of Transmission Efficiency by Improving Friction Coefficient Between Elements and Pulleys of a Belt CVT
- Theoretical Analysis for a Damping Ratio of a Jointed Cantibeam
- Fundamental Study on Three-Dimensional Machining : Part 2,Prediction of Chip Formation and Cutting Force in Turning
- Experimental Study on the Instantaneous Cutting Forces in Metal Cutting with Oscillating Tools
- Turbulent Shear Flow in Hydrostatic Thrust Bearings
- Inertia Effects in the Turbulent Shear Flow of the Lubricant Film
- One Proposal to the Computing Procedure of CAD Considering a Bolted Joint : Study on the CAD for Machine Tool Structures, Part 2
- Influences of Collared Ribs and Core-Holes on the Static Stiffness of Cylindrical Column : Study on the C.A.D for Machine Tool Structures, Part 1
- Study on the Damping Capacity of Bolted Joints : Effects of the Joint Surfaces Condition
- Study on the Horizontal Bending Stiffness of Bulletin of the Bolted Joint
- Force Characteristics between Magnetic Poles with a Finite Dimensional Groove
- Basic Stady on the Hydrostatic Guideways : 1st Report, Theoretical Analysis of the Motion of Table with a Single Recess
- Basic Study on the Hydrostatic Guideways : 2nd Report, The Experimental Investigation of a Table with a Single Recess
- Fundamental Study on Three-Dimensional Machining : Part 1,Theoretical Prediction of Chip Formation and Cutting Force
- Some Effects of Environment of Work Surface in Metal Cutting : 1st Report, The Effects on Cutting Force, Cutting Ratio and Surface Roughness in Machining of Copper
- On the Tool Wear in Cutting of Plastics
- Approximate Solution of Elastic and Damping Properties of Oil-Film in Journal Bearings
- Unbalance Vibration of a Rotor-Bearing System Supported by Floating-Ring Journal Bearings
- A Few New Methods of Metal Cutting to Get a Fine Surface at Low Speed : Sub-zero-, Reversal Finish-, and Ultrasonic Cutting