Fundamental Study on Three-Dimensional Machining : Part 2,Prediction of Chip Formation and Cutting Force in Turning

スポンサーリンク

概要

著者

関連論文

Progress of "Predictive" Theories in Metal Cutting
Theoretical Analysis for a Damping Ratio of a Jointed Cantibeam
Fundamental Study on Three-Dimensional Machining : Part 2,Prediction of Chip Formation and Cutting Force in Turning
Experimental Study on the Instantaneous Cutting Forces in Metal Cutting with Oscillating Tools
One Proposal to the Computing Procedure of CAD Considering a Bolted Joint : Study on the CAD for Machine Tool Structures, Part 2
Influences of Collared Ribs and Core-Holes on the Static Stiffness of Cylindrical Column : Study on the C.A.D for Machine Tool Structures, Part 1
Study on the Damping Capacity of Bolted Joints : Effects of the Joint Surfaces Condition
Study on the Horizontal Bending Stiffness of Bulletin of the Bolted Joint
Basic Stady on the Hydrostatic Guideways : 1st Report, Theoretical Analysis of the Motion of Table with a Single Recess
Basic Study on the Hydrostatic Guideways : 2nd Report, The Experimental Investigation of a Table with a Single Recess
Fundamental Study on Three-Dimensional Machining : Part 1,Theoretical Prediction of Chip Formation and Cutting Force
Some Effects of Environment of Work Surface in Metal Cutting : 1st Report, The Effects on Cutting Force, Cutting Ratio and Surface Roughness in Machining of Copper
On the Tool Wear in Cutting of Plastics
A Few New Methods of Metal Cutting to Get a Fine Surface at Low Speed : Sub-zero-, Reversal Finish-, and Ultrasonic Cutting

もっと見る

スポンサーリンク