Vibration of a Shaft Passing through a Critical Speed : 1st Report Experiments and Numerical Solutions
スポンサーリンク
概要
- 論文の詳細を見る
The vibrational problem which occurs during passage through a critical speed has been investigated with regard to the maximum deflection of shaft. In this paper, we shall study the vibrational characteristics, such as the deflection of a shaft, the angular velocity of whirling motion and the phase angle between the unbalance and the whirling motion, under a uniform angular acceleration over the wide range of angular velocity of a shaft. From the numerical solutions and the experiments on a simple system with one disk, it is clarified that the amplitude of the whirling motion causes a beat after running through the critical speed and in case of acceleration the maximum (minimum) amplitude of beat occurs when the angular velocity of the whirling motion becomes maximum (minimum) and that the phase angle becomes nπ+π/2 radians when the angular velocity of whirling is equal to the angular frequency corresponding to the critical speed of the system.
- 一般社団法人日本機械学会の論文
著者
-
Yanabe Shigeo
Course Tokvo Institute Of Technology.
-
TAMURA Akiyoshi
Tokyo Institute of Technology.
-
Tamura Akiyoshi
Tokyo Institute Of Technology
関連論文
- Vibration of a Shaft Passing through a Critical Speed : 1st Report Experiments and Numerical Solutions
- Multi-plane Balancing of Flexible Rotor Consisting of Two Disks
- Vibration of a Shaft Passing through a Critical Speed : 2nd Report, Approximate Equations
- Stability of a System Consisting of Flexible Rotor and Flexibly Mounted Journal Bearings
- Vibrational Characteristics of Friction Between Gear Teeth
- Experimental Study of Whirl Instability for Externally Pressurized Air Journal Bearings
- Pressure Distribution of Oil Film Caused by Unbalance Whirl
- On the Vibrations of Horizontal Shaft Supported in Oil Lubricated Journal Bearings
- Whirl Instability of Externally Pressurized Gas Journal Bearing
- Coupled Torsional-flexural Vibration of a Shaft in a Geared System of Rotors : 1st Report
- Stability Characteristics of Spherical Spiral Groove Bearings : 2nd Report, Experimental Study
- Stability Characteristics of Spherical Spiral Groove Bearings : 1st Report, Theoretical Analysis
- Dynamic Characteristics of a Gear train System with Softly Supported Shafts
- Dynamical Pressure Distribution in Aerodynamic Bearing
- High Speed Positioning Control of a Flexible System
- Fluid Inertia Effects on the Characteristics of Spherical Hydrostatic Bearings : Part 1 Bearing Forces
- Characteristics of Outwardly Pumping Spherical Spiral Groove Bearings : Part 1, Load Capacity