Vibrational Characteristics of Friction Between Gear Teeth
スポンサーリンク
概要
- 論文の詳細を見る
A lot of investigations have been made on the friction between gear teeth, but most of them discuss its coefficient and few do its vibrational characteristics. As an element in a vibrational system, the friction has two aspects, that is exciting source and damping. In this paper, its vibrational characteristics are discussed. The results obtained in this study are: (1) The peak value of vibrational amplitude response curve caused by the friction, where main component of the vibration is synchronized with meshing frequency, is almost independent of lubricating oil viscosity and transmitting power. (2) Its effect as damping element to forced vibration depends on the kind of exciting source.
- 一般社団法人日本機械学会の論文
著者
-
IIDA HIROSHI
Tokyo Research Laboratories, Tosoh Corporation
-
TAMURA Akiyoshi
Tokyo Institute of Technology.
-
Yamada Yasushi
Konishiroku Photo Ind. Co. Ltd.
-
Tamura Akiyoshi
Tokyo Institute Of Technology
-
Iida Hiroshi
Tokyo Institute Of Technology
関連論文
- Fusion Protein of Interleukin-6 and Interleukin-6 Receptor without a Polypeptide Linker (MEDICAL BIOTECHNOLOGY)
- A Dynamic Analysis of the Plane Crank-and-Rocker Mechanisms with Clearances
- Vibration of a Shaft Passing through a Critical Speed : 1st Report Experiments and Numerical Solutions
- Multi-plane Balancing of Flexible Rotor Consisting of Two Disks
- Vibration of a Shaft Passing through a Critical Speed : 2nd Report, Approximate Equations
- Stability of a System Consisting of Flexible Rotor and Flexibly Mounted Journal Bearings
- Vibrational Characteristics of Friction Between Gear Teeth
- Experimental Study of Whirl Instability for Externally Pressurized Air Journal Bearings
- Pressure Distribution of Oil Film Caused by Unbalance Whirl
- On the Vibrations of Horizontal Shaft Supported in Oil Lubricated Journal Bearings
- Whirl Instability of Externally Pressurized Gas Journal Bearing
- Coupled Torsional-flexural Vibration of a Shaft in a Geared System of Rotors : 1st Report
- Stability Characteristics of Spherical Spiral Groove Bearings : 2nd Report, Experimental Study
- Stability Characteristics of Spherical Spiral Groove Bearings : 1st Report, Theoretical Analysis
- Dynamic Characteristics of a Gear train System with Softly Supported Shafts
- Dynamical Pressure Distribution in Aerodynamic Bearing
- High Speed Positioning Control of a Flexible System
- Fluid Inertia Effects on the Characteristics of Spherical Hydrostatic Bearings : Part 1 Bearing Forces
- Characteristics of Outwardly Pumping Spherical Spiral Groove Bearings : Part 1, Load Capacity
- Coupled Torsional-flexural Vibration of a Shaft in a Geared System : 3rd Report, Dynamic Characteristics of a Counter Shaft in a Gear Train System