Study of Boiling Characteristic Curves in Subcooled Pool Boiling of Water (4th Report, The Mechanism of Heat Transfer in Transition Boiling)
スポンサーリンク
概要
- 論文の詳細を見る
Pool boiling experiments were conducted on a 10 mm dia. heated surface facing upwards in the range of subcooling from 15 to 50K at atmospheric pressure. The heat transfer mechanism in the transitional boiling region can be estimated by a mathematical model based on the mass transfer mechanism of evaporation and condensation through a coalescent vapor bubble. The changes with time of the mass flux of condensation and the dried area on the heated surface, which are important factors governing the characteristics of transition boiling heat transfer, are estimated by a model based on this mass transfer mechanism. An explanation was obtained on the mechanism of liquid invasion onto the heated surface from the correspondence between the change with time of the dried area and local temperature fluctuations of the heated surface.
- 一般社団法人日本機械学会の論文
著者
-
IZUMI Ryotaro
Faculty of Engineering, Nagoya University
-
Izumi Ryotaro
Faculty Of Engineering Nagoya University
-
Izumi Ryotaro
Dept. Of Mech. Eng. Nagoya Univ.
-
INADA Shigeaki
Dept. of Mech. Eng. Gunma Univ.
-
MIYASAKA Yoshiki
Dept. of Mech. Eng. Gunma Univ.
-
INADA Shigeaki
Faculy of Eng. Gunma Univ.
-
MIYASAKA Yoshiki
Faculty of Eng. Gunma Univ.
-
KOBAYASHI Morikazu
Hitachi, Ltd.
-
Kobayashi Morikazu
Hitachi Ltd.
関連論文
- Characteristics of Turbulent Flow and Mass Transfer in Divergent Channels of Rectangular Section
- D108 VISUALIZATION OF THE MICRO-BUBBLE GENERATED IN THE DROPLET IMPINGING ON THE HEATED QUARTZ SURFACE(Multiphase flow measurement)
- Fluid Flow and Heat Transfer in Corrugated Wall Channels : 4th Report, Analysis in the Case Where Channels Are Bent Many Times
- Fluid Flow and Heat Transfer in Corrugated Wall Channels : 3rd Report, Effects of Bending Angles in the Case Where Channels Are Bent Two Times
- Fluid Flow and Heat Transfer in Corrugated Wall Channels : 2nd Report, Experiments in the Case Where Channels Are Bent Perpendicularly Two Times
- Fluid Flow and Heat Transfer in Corrugated Wall Channels : 1st Report, Analysis in the Case Where Channels Are Bent Perpendicularly Two Times
- Heat and Mass Transfer from a Rotating Disk with a Source Flow
- A STUDY ON OPPOSED GASEOUS JET FLAMES STABILIZED IN A UNIFORM AIRSTREAM : 3RD REPORT : SOME EXPERIMENTAL CONSIDERATIONS ON RELATIONS BETWEEN A FLAME SHAPE AND A FLOW PATTERN, AND TEMPERATURE DISTRIBUTIONS
- Disappearance of a Detached Vapor Mass in Subcooled Water : Fluids Engineering, Heat Transfer, Combustion, Power, Thermophysical Properties,
- Study of Boiling Characteristic Curves in Subcooled Pool Boiling of Water (4th Report, The Mechanism of Heat Transfer in Transition Boiling)
- A Study on the Laminar-flow Heat Transfer Between a Two-dimensional Water Jet and a Flat Surface with Constant Heat Flux
- Unsteady Flow and Heat Transfer in a Plate-Fin and Tube Heat Exchanger
- Fluid Flow and Heat Transfer in a Two-dimensional Miter-bend : Study of Unsteady Motion by Numerical Calculations : Heat Transfer, Combustion, Power,Thermophysical Properties
- Fluid Flow and Heat Transfer in a Plate-fin and Tube Heat Exchanger : Analysis of Fluid Flow around Square Cylinder Situated between Parallel Plates
- Fluid Flow and Heat Transfer in a Plate-fin and Tube Heat Exchanger : Analysis of Heat Transfer around a Square Cylinder Situated between Parallel Plates
- Fluid Flow and Heat Transfer in a Two-dimensional Miter-bend : 1st Report, Experiments and Analyses
- Study on Three-Dimensional Flow and Heat Transfer in Miter-Bend : 3rd Report, Effects of Reynolds Number and Aspect Ratio
- Study on Three-Dimensional Flow and Heat Transfer in Miter-Bend : 2nd Report, Analysis of Heat Transfer in Laminar Region
- Study on Three-Dimensional Flow and Heat Transfer in Miter-Bend : 1st Report, Analysis of Flow in Laminar Region
- Performance of the Cross-Flow Heat Exchanger with Variable Physical Properties : 1st Report, In Case where the Overall Heat Transfer Coefficient Is Variable
- Study on a Rotating Condenser with a Scraper : 2nd Report, Analysis of Condensation on Outer Surface of Horizontal Cylinder
- Study on Rotating Condenser with a Scraper : 1st Report, Analysis of Condensation on Outer Surface of Vertical Cylinder
- Study on a Rotating Condenser with a Scraper : 3rd Report, Experiment of Condensation on Outer Surface of Vertical and Horizontal Cylinders
- Study on the Heat Exchanger Using Fluidized Bed : 1st Report, Characteristics of Wall to Bed Heat Transfer in Vertical Tube
- On the Flow of a viscous Free Boundary Jet on a Rotating Disk : 1st Report Theoretical analysis
- Natural Heat Convection in a Vertical Circular Tube
- On the Flow of a Viscous Free Boundary Jet on a Rotating Disk : 2nd Report Comparison of Experimental Results with Caluculated Values by means of Film Thickness
- Transient Heat Transfer for a Water Drop Impinging on a Heated Surface : 1st Report, Effects of Drop Subcooling on the Liquid-Solid Contact State
- Heat and Mass Transfer from a Rotating Disk with a Confronting Stationary Disk
- Performance of Crossflow Heat Exchanger