Metal Forming by Underwater Wire Explosion : 1. An Analysis of Plastic Deformation of Circular Membranes Under Impulsive Loading
スポンサーリンク
概要
- 論文の詳細を見る
The plastic deformation of circular membranes of a strain-rate dependent, work-hardening metal is analyzed based on the strain increment theory. Numerical solutions for aluminum membranes are obtained under various types of loading as well as impulsive pressure pulses caused by underwater wire explosions. When the duration of a loading pulse is less than one-third of the time required to finish the deformation of the membrane, the deflection of a deformed membrane depends almost only on the impulse of the loading pulse and the instantaneous profile of the membrane is found to be trapezoidal during deformation. The relation between impulse of loading and deflection is calculated and illustrated. The forming limit due to peripheral necking is discussed. The neglect of strain-rate dependency of material leads to a notable underestimation of the forming limit.
- 一般社団法人日本機械学会の論文
著者
-
Kato Masana
Faculty of Engineering, Tohoku University
-
Kato Masana
Faculty Of Engineering Tohoku University
-
Tobe Toshimi
Faculty Of Engineering Tohoku University
-
OBARA Haruki
FANUC Ltd.
-
OBARA Haruki
Fujitsu FANUC Ltd.
関連論文
- Evaluation of the Strength of Carburized Spur Gear Teeth Based on Fracture Mechanics
- The Bending Strength of Carburized Fine Module Gear Teeth : Carburizing Conditions and Their Effects on the Fatigue Strength
- Bending Strength of Carburized SCM420H Spur Gear Teeth
- A Study of Pin-Wheel Globoidal Worm Gearing
- High-Speed Forming of Metal Sheets by Electromagnetic Force
- Metal Forming by Underwater Wire Explosions : 2. Experiments on Bulging of Circular Aluminum Sheets by Copper Wire Explosions
- Pressure Pulses Produced by Underwater Wire Explosions in Electric Discharge Metal Forming
- Metal Forming by Underwater Wire Explosion : 1. An Analysis of Plastic Deformation of Circular Membranes Under Impulsive Loading
- Energy Consumption at Underwater Exploding-Wire Gap in Electric Discharge Metal Forming
- Influence of Bearing Positions on Sound Radiation of Single-Stage Spur Gear System
- The Effect of Shot Peening on the Bending Strength of Carburized Gear Teeth
- Deflection of Gear Tooth Considering the Deformation of Rim
- Bending Strength of Spur Gear Teeth : 3rd Report, Fatigue Strength of Carburized Low Alloy Steel under Varying Loads
- Transverse Impact on Beams
- Bending Strength of Spur Gear Teeth : 1st Report, Cumulative Fatigue Damage of Normalized 0.45% Carbon Steel
- Bending Strength of Spur Gear Teeth : 2nd Report, Estimation of Strength based on Plastic Strain Amplitude
- Statistical Analysis of Dynamic Loads on Spur Gear Teeth : Experimental Study
- Statistical Analysis of Dynamic Loads on Spur Gear Teeth : Effect of Shaft Stiffness
- Lateral Vibrations of Cantilevers Considering the Effects of Rotatory Inertia, Shear Flexibility and Solid Viscosity
- Dynamic Loads on Spur Gear Teeth Caused by Teeth Impact
- On the Contact Rolller Test of Materials Used for Marine Reduction Gears (the Journal and the Transactions of the Japan Society of Mechanical Engineers)
- Dynamic Loads on Spur Gear Teeth
- Statistical Analysis of Dynamic Loads on Spur Gear Teeth