毛管法による法線応力差の測定について

概要

論文の詳細を見る
For the measurement of normal stress difference by the capillary tube method, basic equations are derived under the following two assumptions. Assump. 1. Velocity profile is fully developed at the tube exit. Assump. 2. Exit pressure on the center-line of the tube is a function of shear stress at the wall. The results are shown in Table I. In this Table, the equations proposed by several investigators are also shown with their assumptions and approximations. By using the nondimensional group N defined by Eq. (5), which represents the ratio of inertia force to normal stress difference, the exit stress P_w(L) is expressed by Eq.(6). For the range of N≪1, P_w(L) is approximately equal to the normal stress difference T_n and increases with wall shear rate. Generally, P_w(L) depends on N as well as on wall shear rate, and cannot be considered as the material function. It may be anticipated that there is the range of N where P_w(L) becomes a decreasing function of N. Since the pressure term in P_w(L) cannot be neglected and it cannot be determined by the capillary tube method, it is impossible to determine each component of normal stress differences only by the capillary tube method.
社団法人日本材料学会の論文
1973-05-15