Examination of the failure behavior of wood with a short crack in the radial–longitudinal system by single-edge-notched bending test
スポンサーリンク
概要
- 論文の詳細を見る
- Springerの論文
- 2012-10-25
著者
-
Nakao Tetsuya
Faculty Of Science And Engineering Shimane University
-
Yoshihara Hiroshi
Faculty Of Science And Engineering Shimane University
-
SUSANTI Cicilia
Faculty of Forestry, The State University of Papua
-
Nakao Tetsuya
Faculty of Science and Engineering, Shimane University
関連論文
- Accuracy of shear properties of wood obtained by simplified losipescu shear test
- Applicability of the losipescu shear test on the measurement of the shear properties of wood
- Prediction of the buckling stress of intermediate wooden columns using the secant modulus
- Measurement of the shear modulus of wood by static bending tests
- Young's modulus obtained by flexural vibration test of a wooden beam with inhomogeneity of density
- Measurement of the shear modulus of wood by asymmetric four-point bending tests
- Effects of fiber length and orientation on elasticity of fiber-reinforced plywood
- Evaluation of rolling shear strength of plywood by flexural vibration method
- Measurement of mode II fracture toughness of wood by the end-notched flexure test
- Estimation of the shear strength of wood by uniaxial-tension tests of off-axis specimens
- Initial shapes of stress-strain curve of wood specimen subjected to repeated combined compression and vibration stresses and the piezoelectric behavior
- Effects of grain angles of face veneer on surface wave velocities and dynamic shear moduli of wood-based composites
- The relationship between macroscopic strain and crystal lattice strain in wood under uniaxial stress in the fiber direction
- Vibrational properties of wood plastic plywood
- Dynamic properties of three types of wood-based composites
- Relationship between piezoelectric behavior and the stress-strain curve of wood under combined compression and vibration stresses
- Calculation models of pressure and position of curved laminated veneer lumber in molds during pressing
- Influence of loading point on the static bending test of wood
- Measurement of bending properties of wood by compression bending tests
- Mechanical Condensation of Tannin in Acacia mangium Bark
- Influence of span/depth ratio on the measurement of mode II fracture toughness of wood by end-notched flexure test
- Examination of the failure behavior of wood with a short crack in the radial–longitudinal system by single-edge-notched bending test