Young's modulus obtained by flexural vibration test of a wooden beam with inhomogeneity of density
スポンサーリンク
概要
- 論文の詳細を見る
- Springerの論文
- 2006-02-25
著者
-
KUBOJIMA Yoshitaka
Forestry and Forest Products Research Institute
-
TONOSAKI Mario
Forestry and Forest Products Research Institute
-
Kubojima Yoshitaka
Forestry And Forest Products Res. Inst. Ibaraki Jpn
-
YOSHIHARA Hiroshi
Faculty of Science and Engineering, Shimane University
-
Yoshihara Hiroshi
Faculty Of Science And Engineering Shimane University
関連論文
- Shear modulus of several kinds of Japanese bamboo obtained by flexural vibration test
- Present State of Wood Waste Recycling and a New Process for Converting Wood Waste into Reusable Wood Materials
- Ideal utilization of forest resources for sustainable society
- Radial variations of wood properties of an endangered species, Pinus armandii var. amamiana
- Deformation behavior of wood under stress relaxation in a radial direction as a laminated annual-ring structure
- Vibrational properties of wetwood of todomatsu (Abies sachalinensis) at high temperature
- Fixed-fixed flexural vibration testing method of beams for timber guardrails
- Proportional limit of wood obtained from a load-time diagram during an impact bending test
- Accuracy of shear properties of wood obtained by simplified losipescu shear test
- Vibrational properties of heat-treated green wood
- Bending strength and toughness of heat-treated wood
- Applicability of the losipescu shear test on the measurement of the shear properties of wood
- Vibrational properties of Sitka spruce heat-treated in nitrogen gas
- Prediction of the buckling stress of intermediate wooden columns using the secant modulus
- Measurement of the shear modulus of wood by static bending tests
- Young's modulus obtained by flexural vibration test of a wooden beam with inhomogeneity of density
- Measurement of the shear modulus of wood by asymmetric four-point bending tests
- Measurement of mode II fracture toughness of wood by the end-notched flexure test
- Estimation of the shear strength of wood by uniaxial-tension tests of off-axis specimens
- Calculation models of pressure and position of curved laminated veneer lumber in molds during pressing
- Measurement of the refining degree of bamboo charcoal by an alternating current method
- Influence of loading point on the static bending test of wood
- Measurement of bending properties of wood by compression bending tests
- Harvested wood products accounting in the post Kyoto commitment period
- Influence of span/depth ratio on the measurement of mode II fracture toughness of wood by end-notched flexure test
- Fixed-fixed flexural vibration testing method of actual-size bars for timber guardrails
- Examination of the failure behavior of wood with a short crack in the radial–longitudinal system by single-edge-notched bending test