Measurement of mode II fracture toughness of wood by the end-notched flexure test
スポンサーリンク
概要
- 論文の詳細を見る
- Springerの論文
- 2000-08-25
著者
-
YOSHIHARA Hiroshi
Faculty of Science and Engineering, Shimane University
-
Ohta M
Department Of Biomaterial Sciences Graduate School Of Agricultural And Life Sciences The University
-
Ohta Masamitsu
Graduate School Of Agricultural And Life Science The University Of Tokyo
-
Yoshihara H
Shimane Univ. Shimane Jpn
-
Ohta Masamitsu
Graduate School Of Agricultural And Life Sceinces The University Of Tokyo
-
Yoshihara Hiroshi
Faculty Of Science And Engineering Shimane University
関連論文
- Collapsing process simulations of timber structures under dynamic loading II : simplification and quantification of the calculating method
- Vibrational properties of wetwood of todomatsu (Abies sachalinensis) at high temperature
- Accuracy of shear properties of wood obtained by simplified losipescu shear test
- Vibrational properties of heat-treated green wood
- Bending strength and toughness of heat-treated wood
- Applicability of the losipescu shear test on the measurement of the shear properties of wood
- Vibrational properties of Sitka spruce heat-treated in nitrogen gas
- Prediction of the buckling stress of intermediate wooden columns using the secant modulus
- Measurement of the shear modulus of wood by static bending tests
- Intercalation of wood charcoal with sulfuric acid
- Young's modulus obtained by flexural vibration test of a wooden beam with inhomogeneity of density
- Measurement of the shear modulus of wood by asymmetric four-point bending tests
- Hardness distribution on wood surface
- Measurement of mode II fracture toughness of wood by the end-notched flexure test
- Collapsing process simulations of timber structures under dynamic loading I : simulations of two-story frame models
- Estimation of the shear strength of wood by uniaxial-tension tests of off-axis specimens
- Deformation analysis of timber-framed panel dome structure I : simulation of a dome model connected by elastic springs
- Deviations of kerf by handsaws III : the bend of saw blade by unsymmetrical set
- Collapsing process simulations of timber structures under dynamic loading III : numerical simulations of real-size wooden houses
- Calculation models of pressure and position of curved laminated veneer lumber in molds during pressing
- Influence of loading point on the static bending test of wood
- Variability of fracture toughness by the crack tip position in an annual ring of coniferous wood
- Measurement of bending properties of wood by compression bending tests
- Influence of span/depth ratio on the measurement of mode II fracture toughness of wood by end-notched flexure test
- Internal-check variation in boxed-heart square timber of sugi (Cryptomeria japonica) cultivars dried by high-temperature kiln drying
- Eye fatigue-reduction effect of wood rim cover on liquid crystal display
- Surface-check variation in boxed-heart square timber of sugi (Cryptomeria japonica) cultivars dried by the conventional kiln drying
- Examination of the failure behavior of wood with a short crack in the radial–longitudinal system by single-edge-notched bending test