Atmosphere Controlled Hot Thermocouple Method and Crystallization Phenomenon of CaO–Al2O3 Eutectic Slag
スポンサーリンク
概要
- 論文の詳細を見る
A desulfurization slag is difficult to recycle, since there is a possibility to elute a sulfur containing solution. To promote the recycle of the desulfurization slags, it is important to know the physicochemical properties of the slag. In addition, desulfurization process could be modified, when the sulfur behavior in the slag was understood. In this study, the effect of sulfur and oxygen partial pressure on the crystallization behavior was investigated using Hot Thermocouple Technique. Three different atmospheres were established in the electric furnace through the modification of experimental apparatus. One was an argon without deoxidation, the second was an argon with Ti plate (Ar+Ti) which was located in the electric furnace for deoxidation of argon gas, and the third was an argon with CaS pellet located on the Ti plate (Ar+Ti+CaS) in which the partial pressure of SO2 increased with the decrease of the oxygen partial pressure. The nose position of TTT diagram of CaO-Al2O3 eutectic composition under Ar atmosphere was 7 s at 1100℃, while the nose positions under Ar+Ti and Ar+Ti+CaS were 7 s at 1150℃. TTT diagrams under Ar+Ti and Ar+Ti+CaS, which are lower oxygen potential and higher SO2 potential, showed the earlier crystallization behavior in the higher temperature region than the nose position. From the results of XRD analysis, the sulfur added to the slag existed in the monocalcium aluminate (CaO・Al2O3) primary crystal. When the content of CaS increased, a formation of CaO through oxidation increased and the tricalcium aluminate (3CaO・Al2O3) was formed as a primary crystal, in which the sulfur content was higher than the eutectic structure in the matrix.
- 2011-12-15
著者
-
Suzuki Ryosuke
Graduate School Of Science And Technology Niigata University
-
Kashiwaya Yoshiaki
Faculty Of Engineering Hokkaido University
-
Kashiwaya Yoshiaki
Div. Of Materials Sci. Graduate School Of Engineering Hokkaido Univ.
-
Kashiwaya Yoshiaki
Graduate School Of Energy Science And Technology Kyoto University
-
KUSADA Yasuaki
Graduate School of Eng., Hokkaido University
-
Suzuki Ryosuke
Graduate School Of Eng. Faculty Of Engineering Hokkaido University
関連論文
- An Investigation of the Crystallization of a Continuous Casting Mold Slag Using the Single Hot Thermocouple Technique
- Development of Double and Single Hot Thermocouple Technique for in situ Observation and Measurement of Mold Slag Crystallization
- Analysis of the Transition State of the Carbon and Iron Oxide Mixture Activated by Mechanical Milling
- Phosphorous Partition in Dephosphorization Slag Occurring with Crystallization at Initial Stage of Solidification
- Crystallization Behaviors Concerned with TTT and CCT Diagrams of Blast Furnace Slag Using Hot Thermocouple Technique
- Quantitative Estimation of Coupling Phenomenon between Reduction and Gasification on the Facing Pair of Iron Oxide and Graphite
- Characteristics of Nano-reactor and Phenomena during Mechanical Milling of Hematite-Graphite Mixture
- Gas Evolution during Mechanical Milling of Hematite-Graphite Mixture
- Intensive Improvement of Reduction Rate of Hematite-Graphite Mixture by Mechanical Milling
- Reaction Behavior of Facing Pair Between Hematite and Graphite: A Coupling Phenomenon of Reduction and Gasification
- In Situ Observation of Reduction Behavior of Hematite with Solid Carbon and Crystallographic Orientation between Hematite and Magnetite
- Simulation Test for Crystallization of Inclusions in Semi-killed Steels during Heat Treatment Prior to Hot Rolling
- Catalytic Effect of Slags on the Formation of Biodiesel Fuel
- In Situ Observation of Diamond Gasification and the Crystallographic Relationship of Graphite Formed on the Surface of Diamond
- Kinetic Analysis of the Gasification of Diamond
- Latent Heat of Amorphous Slags and Their Utilization as a High Temperature PCM
- Effect of Oxides and Carbonate on the Reaction of Hematite and Graphite Mixture Obtained by the Mechanical Milling
- Mechanism of the Formation of Slag Particles by the Rotary Cylinder Atomization
- Development of a Rotary Cylinder Atomizing Method of Slag for the Production of Amorphous Slag Particles
- Thermodynamic Analysis on the Dust Generation from EAF for the Recycling of Dust
- Hatching and Distribution of Actin Filaments in Mouse Blastocysts Whose Activities of Protein Kinase A were Suppressed by H-89
- Hatching and Distribution of Actin Filaments in Mouse Blastocysts Whose Activities of Protein Kinase A were Suppressed by H-89
- Binding Energy of Carbon Implanted into Hematite and in situ Observation of Reaction Behavior during Heating Up Experiment
- Effect of Sulfur on the TTT Diagram of CaO–Al2O3 Slag at Eutectic Composition
- Atmosphere Controlled Hot Thermocouple Method and Crystallization Phenomenon of CaO–Al2O3 Eutectic Slag
- Kinetic Analysis of the Decomposition Reaction of CH4 Injecting into Molten Slag
- Data Position Detection Using Fast Fourier Transform Cross-Correlation Method for Holographic Memory
- Thermodynamics of Impurities in Pure Iron Obtained by Hydrogen Reduction
- Simulation of Blast Furnace Operation with Intensive Hydrogen Injection
- Thermodynamics of Impurities in Pure Iron Obtained by Hydrogen Reduction
- Preface to the Special Issue on "Green Energy Ironmaking and Steelmaking –Production of Green Energy and Its Use in Ironmaking and Steelmaking–"