A Criterion for Water Modeling of Non-isothermal Melt Flows in Continuous Casting Tundishes
スポンサーリンク
概要
- 論文の詳細を見る
Water modeling of tundish melt flows offers useful insight into the underlying flow phenomena occurring in the tundish. To date most of the water modeling studies have been carried out under isothermal conditions; usually at room temperature. However, fluid flow in continuous casting tundishes is normally not isothermal. By analyzing the dimensionless turbulent Navier-Stokes equation, a modeling criterion is proposed which may be adequate to simulate the flow of molten metal in continuous casting tundishes by means of water modeling. The criterion was tested for a few hypothetical test cases by means of water modeling as well as mathematical modeling. Good agreement between the residence time distribution curves was obtained in the test cases considered when the proposed modeling criterion was satisfied.
- 社団法人 日本鉄鋼協会の論文
- 1996-06-15
著者
-
Sahai Yogeshwar
Department Of Materials Science And Engineering The Ohaio State University Columbus
-
Damle Chandrashekhar
Department Of Materials Science And Engineering The Ohio State University
-
Sahai Yogeshwar
Department Of Materials Science And Engineeering The Ohio State University
関連論文
- Criteria for Water Modeling of Melt Flow and Inclusion Removal in Continuous Casting Tundishes
- (1) Simulation of Melt Flow and Inclusion Flotation in Continuous Casting Tundishes (Miscellany)
- Melt Flow Characterization in Continuous Casting Tundishes
- Modeling of Fluid Flow and Heat Transfer in Twin-Roll Casting of Aluminum Alloys
- Viscosity and Density of Molten Salts Based on Equimolar NaCl-KCl
- A Criterion for Water Modeling of Non-isothermal Melt Flows in Continuous Casting Tundishes
- Mathematical Modeling of Thermally Induced Stresses in Two-roll Melt Drag Thin Strip Casting of Steel
- Interfacial Behavior and Coalescence of Aluminum Drops in Molten Salts
- Mathematical Modeling of Fluid Flow, Heat Transfer, and Solidification in Two-roll Melt Drag Thin Strip Casting of Steel
- Surface Tension and Density of Molten Salts Based on Equimolar NaCl-KCl with Addition of Fluorides
- Coalescence Behavior of Aluminum Alloy Drops in Molten Salts
- Wetting Behavior in Aluminum-Alumina-Salt Systems
- Interaction and Interfacial Tension between Aluminum Alloys and Molten Salts
- Modeling of Thermo-Mechanical Stresses in Twin-Roll Casting of Aluminum Alloys
- Chemical Interactions of Dross with Water and Water Vapor in Aluminum Scrap Remelting
- Interfacial Tension between Aluminum Alloy and Molten Salt Flux
- Mathematical Modeling of Inclusion Transport and Removal in Continuous Casting Tundishes.
- The Effect of Tracer Density on Melt Flow Characterization in Continuous Casting Tundishes. A Modeling Study.