Melt Flow Characterization in Continuous Casting Tundishes
スポンサーリンク
概要
- 論文の詳細を見る
Melt flow in continuous casting tundishes is normally characterized by a combined model. The model is used to analyze the residence time distribution of fluid in a tundish. In this model, the fluid volume in tundish is considered to be consisting of the plug flow, well-mixed flow, and dead volumes. Although this model was proposed over 20 years ago, most researchers have either used it incorrectly or made an assumption in analyzing melt flow in tundishes. Both approaches may lead to incorrect and misleading calculations of the dead volume. In this paper, the combined model has been discussed and its correct application to tundish melt flow has been outlined.
- 社団法人 日本鉄鋼協会の論文
- 1996-06-15
著者
-
Sahai Yogeshwar
Department Of Materials Science And Engineering The Ohaio State University Columbus
-
Emi Toshihiko
Base Metal Research Station Institute For Advanced Materials Processing Tohoku University
-
Sahai Yogeshwar
Department Of Materials Science And Engineeering The Ohio State University
関連論文
- Criteria for Water Modeling of Melt Flow and Inclusion Removal in Continuous Casting Tundishes
- (1) Simulation of Melt Flow and Inclusion Flotation in Continuous Casting Tundishes (Miscellany)
- Melt Flow Characterization in Continuous Casting Tundishes
- Modeling of Fluid Flow and Heat Transfer in Twin-Roll Casting of Aluminum Alloys
- Viscosity and Density of Molten Salts Based on Equimolar NaCl-KCl
- A Criterion for Water Modeling of Non-isothermal Melt Flows in Continuous Casting Tundishes
- Mathematical Modeling of Thermally Induced Stresses in Two-roll Melt Drag Thin Strip Casting of Steel
- Interfacial Behavior and Coalescence of Aluminum Drops in Molten Salts
- Mathematical Modeling of Fluid Flow, Heat Transfer, and Solidification in Two-roll Melt Drag Thin Strip Casting of Steel
- Surface Tension and Density of Molten Salts Based on Equimolar NaCl-KCl with Addition of Fluorides
- Coalescence Behavior of Aluminum Alloy Drops in Molten Salts
- Wetting Behavior in Aluminum-Alumina-Salt Systems
- Interaction and Interfacial Tension between Aluminum Alloys and Molten Salts
- Modeling of Thermo-Mechanical Stresses in Twin-Roll Casting of Aluminum Alloys
- Chemical Interactions of Dross with Water and Water Vapor in Aluminum Scrap Remelting
- Interfacial Tension between Aluminum Alloy and Molten Salt Flux
- Mathematical Modeling of Inclusion Transport and Removal in Continuous Casting Tundishes.
- The Effect of Tracer Density on Melt Flow Characterization in Continuous Casting Tundishes. A Modeling Study.