Summary in the Project "Towards Innovation in Superplasticity"
スポンサーリンク
概要
- 論文の詳細を見る
- Japan Institute of Metalsの論文
- 1999-08-20
著者
-
HIGASHI Kenji
Department of Materials Science, Graduate School of Engineering, Osaka Prefecture University
-
SAKUMA Taketo
Department of Advanced Materials Science, Graduate School of Frontier Science, The University of Tok
-
Higashi Kenji
Department Of Materials Science Graduate School Of Engineering Osaka Prefecture University
-
Higashi Kenji
Department Of Metallurgy And Materials Science College Of Engineering Osaka Prefecture University
-
Sakuma Taketo
Department Of Materials Science Faculty Of Engineering The University Of Tokyo
-
Sakuma Taketo
Department Of Advanced Materials Science The University Of Tokyo
関連論文
- 高ひずみ速度でのAZ31マグネシウム合金の機械的特性と成形性に及ぼす集合組織の影響
- 第一原理計算概論と化合物・希薄合金への適用 (特集 状態図の第一原理熱力学計算--現状と展望)
- Texture Randomization of AZ31 Magnesium Alloy Sheets for Improving the Cold Formability by a Combination of Rolling and High-Temperature Annealing
- Effect of Tool Materials on Dynamic Friction Characteristics and Microstructural Evolution at Elevated Temperature in Extruded AZ31 Magnesium Alloy
- Current-Voltage Characteristics Across Small Angle Symmetric Tilt Boundaries in Nb-Doped SrTiO_3 Bicrystals
- GeO_2-doping Dependence of High Temperature Superplastic Behavior in 3Y-TZP
- Criterion for High Temperature Failure and Grain Boundary Chemistry in Superplastic TZP
- Dissimilar Welding of Al and Mg Alloys by FSW
- Development of Constitutive Equation on Superplastic RS P/M Mg-Y-Zn Alloy
- Effect of Reduction Ratio of Hot-Extrusion on Microstructures of Superplastic Si_3N_4whisker/Al-Mg-Si Alloy Composites Studied by Transmission Electron Microscopy
- The Effect of Deformation Temperature on Microstructure and Superplastic Flow in Al-Cu-Mg/Si_3N_4p Composites
- Effect of Cell Size on the Dynamic Compressive Properties of Open-Celled Aluminum Foams
- The Critical Stress at the Interface for Cavity Nucleation in Superplastic Aluminum Matrix Composites Reinforced with Si_3N_4 Particles
- Development of a Closed Cell Aluminum Alloy Foam with Enhancement of the Compressive Strength
- High-Temperature Plastic Flow in Pre-Annealed Zr-Al-Ni-Cu Bulk Metallic Glass in a Supercooled Liquid Region
- High Temperature Deformation Behavior of [0001] Symmetrical Tilt Σ7 and Σ21 Grain Boundaries in Alumina Bicrystals
- Structure of [110] tilt grain boundaries in zirconia bicrystals
- Suppression of Macroscopic Defects through the Control of Friction between Workpiece and Dies in a Forged Magnesium Alloy Part with Ribs
- New Forming Process of Three-Dimensionally Shaped Magnesium Parts Utilizing High-Strain-Rate Superplasticity
- Secondary Processing of AZ31 Magnesium Alloy Concomitant with Grain Growth or Dynamic Recrystallization
- Plane-Strain Fracture Toughness on Thin AZ31 Wrought Magnesium Alloy Sheets
- The Grain Size Dependence on Diffusion Bonding Behavior in Superplastic Mg Alloys
- Experimental Study on Diffusion Bonding in Pure Magnesium
- Fracture Mechanism and Forming Limit in Deep-Drawing of Magnesium Alloy AZ31
- Effect of Small Addition of Zinc on Creep Behavior of Tin
- Effect of Pre-Introduced Shear Bands Direction on Deformation Behavior in Zr_Al_Ni_5Cu_ Bulk Metallic Glass
- Effect of Initial Grain Size on Dynamically Recrystallized Grain Size in AZ31 Magnesium Alloy
- Optimum Processing and Tool Controls for Three-Dimensional Friction Stir Welding
- Optimization of Welding Condition for Nonlinear Friction Stir Welding
- Optimization of Rolling Conditions in Mg-Al-Ca Alloy Containing Insoluble Second Phase Particles
- Effects of Size and Volume Fraction of Precipitated Crystalline Phase Induced by Friction Stir Processing on Hardness in Zr-Al-Ni-Cu Bulk Metallic Glass
- Cavitation Behavior in Superplastically Deformed Zn-22mass% Al Alloy at Room Temperature
- Energy Absorption in Closed-Cell Al-Zn-Mg-Ca-Ti Foam
- High-Strain-Rate Superplasticity in Metallic Materials and the Potential for Ceramic Materials
- Grain Boundary Energy and Tensile Ductility in Superplastic Cation-doped TZP
- Post-characteristics of Formed Zn-22 mass%Al Alloy to Seismic Damper for General Residence
- Room Temperature Deformation Behavior of Zn-22mass%Al Alloy with Nanocrystalline Structure
- Investigation on Dynamic Friction Properties of Extruded AZ31 Magnesium Alloy Using by Ring Upsetting Method
- Local Bonding States of Titanium and Germanium-doped Tetragonal Zirconia Polycrystal and Their Correlation to High Temperature Ductility
- Creep Deformation Mechanisms in Coarse-Grained Solid Solution Mg Alloys
- The Effect of Ram Speed on Mechanical and Thermal Properties in ECAE Process Simulation
- High Cycle Fatigue Property of Extruded Non-Combustible Mg Alloy AMCa602
- High Cycle Fatigue Property and Micro Crack Propagation Behavior in Extruded AZ31 Magnesium Alloys
- Superplasticity at Room Temperature in Zn-22Al Alloy Processed by Equal-Channel-Angular Extrusion
- Pulmonary Fibrosis Associated with Polymyalgia Rheumatica
- Environmentally Friendly Composite Film of Anodizing and Electrodeposition Coating Having a High Corrosion Resistance on Magnesium Alloy AZ91D
- High Corrosion and Weather Resistant Anionic Resin Coating for 2014 T6 Aluminum Alloys Which Maintains Mirror Luster
- Optimization of Environmentally Friendly Anodic Oxide Film for Magnesium Alloys
- Elastic Constants of AlLi from First Principles
- Cold-Rolled Mg-14 mass%Li-1 mass%Al Alloy and Its Friction Stir Welding
- High-Strengthening of Mg-5.5mass%Y-4.3mass%Zn Cast Alloy by Friction Stir Processing
- Effect of Microstructural Change on High-Temperature Deformation in Pre-Annealed Zr_Al_Ni_Cu_ Bulk Metallic Glass
- Deformation Mechanism of Fine-Grained Superplasticity in Metallic Materials Expected from the Phenomenological Constitutive Equation
- Microstructure in Zn-Al Alloys after Equal-Channel-Angular Extrusion
- Internal Friction Behavior of Alumina Polycrystals with Engineered Grain Boundaries
- Materials Processing for Structural Stability in a ZK60 Magnesium Alloy
- Mechanical Properties of Mg-Y-Zn Alloy Processed by Equal-Channel-Angular Extrusion
- High-Strain-Rate Superplasticity in an AZ91 Magnesium Alloy Processed by Ingot Metallurgy Route
- Grain Size Control of Commercial Wrought Mg-Al-Zn Alloys Utilizing Dynamic Recrystallizaiton
- Effect of Grain Refinement on Tensile Ductility ZK60 Magnesium Alloy under Dynamic Loading
- Superplasticity of a Particle-Strengthened WE43 Magnesium Alloy
- Superplastic Deformation Behavior in Commercial Magnesium Alloy AZ61
- Low Temperature Superplasticity in a ZK60 Magnesium Alloy
- Processing of Ductile Magnesium Alloy under Dynamic Tensile Loading
- Improvement of Crashworthiness in Ultra Lightweight Metallic Foam by Heat-Treatment for Microstructural Modification of Base Material
- Improvement of High-temperature Creep Resistance in Polycrystalline Al_2O_3 by Cations Co-doping
- Small Dopant Effect on Static Grain Growth and Flow Stress in Superplastic TZP
- Effect of Chemical Bonding State on High-temperature Plastic Flow Behavior in Fine-grained, Polycrystalline Cation-doped Al_2O_3
- Grain Boundary Sliding and Atomic Structures in Alumina Bicrystals with [0001] Symmetric Tilt Grain Boundaries
- PREFACE
- Effect of GeO_2 and NdO_ Co-doping on High-temperature Ductility in TZP
- Summary in the Project "Towards Innovation in Superplasticity"
- Grain boundary structure and chemical bonding state of superplastic SiO_2-doped TZP
- Superplastic Behavior in GeO_2 Doped Y-TZP
- Ab Initio Calculation on the Structure and Elastic Properties of a Magnesium-Lithium Alloy
- Changes of Shape and Stress Distribution during Free Bulging in Axisymmetrically Blow-Formed Superplastic Sheet
- Novel Electroforming Process for Bulk Nanocrystalline Ni-W Alloys with Minimizing W-Concentration Gradient and Fluctuation
- Application of Electroforming Process to Bulk Amorphous Ni-W Alloy
- Effects of Flow Stress and Grain Size on the Evolution of Grain Boundary Microstructure in Superplastic 5083 Aluminum Alloy
- Ni-W Amorphous/Nanocrystalline Duplex Composite Produced by Electrodeposition
- Influence of Bath Composition on Tensile Ductility in Electrodeposited Bulk Nanocrystalline Nickel
- MALIGNANT DEGENERATION OF BENIGN CYSTIC TERATOMA OF THE BILATERAL OVARIES : ADENOSQUAMOUS CARCINOMA IN THE RIGHT TUMOUR AND SQUAMOUS CARCINOMA IN THE LEFT TUMOUR
- Effect of Titania Doping on Phase Stability of Zirconia Bioceramics in Hot Water
- Clarification of the Necessary Value of Surface Roughness for Developing Luster on an AZ31 Magnesium Alloy Surface with or without Acid Aqueous Solution Treatment
- Addition of an Aminic Antioxidant to a Hindered Ester-Based Heat Resisting Oil to Improve Lubrication for Press Forming of Magnesium Alloy Sheets
- Tribological Properties of Hybrid Process DLC Coating against Magnesium Alloy
- Optimization of Die Material and Its Surface Coating for Press Forming Magnesium Alloy
- Effect of Small Amount of Insoluble Dopant on Tetragonal to Monoclinic Phase Transformation in Tetragonal Zirconia Polycrystal
- Surface Treatment to Provide a Metallic Luster to AZ31 Magnesium Alloy
- Experimental Investigation of Cavitation Behavior in AZ61 Magnesium Alloy
- High-Strain-Rate Superplasticity and Its Applications
- Special Issue on Platform Science and Technology for Advanced Magnesium Alloys IV
- Rolling Texture Evolution of AZ31 Magnesium Alloy Sheets by Isothermal Eccentric-Rolls Drawing
- PREFACE
- PREFACE
- The Optimal Surface Roughness Condition on Diffusion Bonding
- Dynamic Friction Properties and Microstructural Evolution in AZ31 Magnesium Alloy at Elevated Temperature during Ring Compression Test
- PREFACE
- Regulation by estrogen and progesterone of protein kinases in rabbit myometrium.
- Dissociation of alterations in levels of myosin light chain kinase and cyclic AMP-dependent protein kinase in rabbit myometrium during pregnancy.