Development of a Closed Cell Aluminum Alloy Foam with Enhancement of the Compressive Strength
スポンサーリンク
概要
- 論文の詳細を見る
- Japan Institute of Metalsの論文
- 2001-10-20
著者
-
HIGASHI Kenji
Department of Materials Science, Graduate School of Engineering, Osaka Prefecture University
-
HARA Shigeta
Department of Materials Science and Processing, Graduate School of Engineering, Osaka University
-
Hara Shigeta
Department Of Materials Science And Processing Graduate School Of Engineering Osaka University
-
Higashi Kenji
Department Of Materials Science Graduate School Of Engineering Osaka Prefecture University
-
Higashi Kenji
Department Of Metallurgy And Materials Science Osaka Prefecture University
-
MUKAI Toshiji
Osaka Municipal Technical Research Institute
-
MIYOSHI Tetsuji
Shinko Wire Company
-
Higashi Kenji
Department Of Metallurgy And Materials Science College Of Engineering Osaka Prefecture University
-
Miyoshi Tetsuji
Shinko Wire Co. Ltd.
関連論文
- Texture Randomization of AZ31 Magnesium Alloy Sheets for Improving the Cold Formability by a Combination of Rolling and High-Temperature Annealing
- Effect of Tool Materials on Dynamic Friction Characteristics and Microstructural Evolution at Elevated Temperature in Extruded AZ31 Magnesium Alloy
- Microscopic Structure and Thermoelectric Properties of ZnO Ceramics with Various Added Elements Prepared by the Polymerized Complex Method
- Thermoelectric Properties of Na_xCo_2O_4 Prepared by the Polymerized Complex Method and Spark Plasma Sintering
- Dissimilar Welding of Al and Mg Alloys by FSW
- Development of Constitutive Equation on Superplastic RS P/M Mg-Y-Zn Alloy
- Development of Swirling Flow Generator in Immersion Nozzle
- Swirling Flow Effect in Immersion Nozzle on Flow in Slab Continuous Casting Mold
- Formation of Fine Bubble through Swirling Motion of Liquid Metal in the Metallurgical Container
- Effect of Reduction Ratio of Hot-Extrusion on Microstructures of Superplastic Si_3N_4whisker/Al-Mg-Si Alloy Composites Studied by Transmission Electron Microscopy
- The Effect of Deformation Temperature on Microstructure and Superplastic Flow in Al-Cu-Mg/Si_3N_4p Composites
- Swirling Flow Effect in Off-center Immersion Nozzle on Bulk Flow in Billet Continuous Casting Mold
- Swirling Flow Effect in Submerged Entry Nozzle on Bulk Flow in High Throughput Slab Continuous Casting Mold
- Effect of Cell Size on the Dynamic Compressive Properties of Open-Celled Aluminum Foams
- The Critical Stress at the Interface for Cavity Nucleation in Superplastic Aluminum Matrix Composites Reinforced with Si_3N_4 Particles
- Swirling Flow Effect in Bottomless Immersion Nozzle on Bulk Flow in High Throghput Slab Continuous Casting Mold
- Swirling flow control in immersion nozzle for Continuous Casting process
- 電析中におけるAu(100)/Cd〔2+〕界面上での表面アロイ層形成
- Dehydrogenation Properties of Kish Graphite Powder Mechanically Milled in H2 Atmosphere (特集 炭素系機能材料)
- Temperature Dependence of Inward Diffusion of Underpotentially-Deposited Cd into a Au (100) Bulk Phase under Electrochemical Environment
- Development of a Closed Cell Aluminum Alloy Foam with Enhancement of the Compressive Strength
- Prospect for Innovative Steelmaking Process in the Forthcoming Century
- In-situ Electrochemical Atomic Force Microscopy with Atomic Resolution of Ni (110) in Neutral and Alkaline Aqueous Solution
- In Situ Electrochemical Atomic Force Microscopy with Atomic Resolution of Fe(110) in Sodium Sulfate Aqueous Solution
- Synthesis of c-axis Oriented Na_xCo_2O_4 Thermoelectric Oxide by the Citric Acid Complex Method
- Peculiar Wetting of Liquid Cu on the Surface of Oxidized Solid Fe
- Effects of Y_2O_3 and Y Addition on Thermoelectric Properties of β-FeSi_2 Synthesized by Mechanical Alloying and Hot Pressing
- Mechanism of Dioxins/Furans Formation at High Temperature in Combustion Processes
- Application of Capillarity of Solid CaO to Dephosphorization of Hot Metals
- Application of Capillarity of Solid CaO to Dephosphorization of Hot Metals
- High-Temperature Plastic Flow in Pre-Annealed Zr-Al-Ni-Cu Bulk Metallic Glass in a Supercooled Liquid Region
- Suppression of Macroscopic Defects through the Control of Friction between Workpiece and Dies in a Forged Magnesium Alloy Part with Ribs
- New Forming Process of Three-Dimensionally Shaped Magnesium Parts Utilizing High-Strain-Rate Superplasticity
- Secondary Processing of AZ31 Magnesium Alloy Concomitant with Grain Growth or Dynamic Recrystallization
- Plane-Strain Fracture Toughness on Thin AZ31 Wrought Magnesium Alloy Sheets
- The Grain Size Dependence on Diffusion Bonding Behavior in Superplastic Mg Alloys
- Experimental Study on Diffusion Bonding in Pure Magnesium
- Fracture Mechanism and Forming Limit in Deep-Drawing of Magnesium Alloy AZ31
- Effect of Partial Substitutions of Rare-earth Metals for Na-site on the Thermoelectric Properties of Na_xCo_2O_4 Prepared by the Polymerized Complex Method
- Effect of Small Addition of Zinc on Creep Behavior of Tin
- Effect of Pre-Introduced Shear Bands Direction on Deformation Behavior in Zr_Al_Ni_5Cu_ Bulk Metallic Glass
- Effect of Initial Grain Size on Dynamically Recrystallized Grain Size in AZ31 Magnesium Alloy
- Optimum Processing and Tool Controls for Three-Dimensional Friction Stir Welding
- Optimization of Welding Condition for Nonlinear Friction Stir Welding
- Optimization of Rolling Conditions in Mg-Al-Ca Alloy Containing Insoluble Second Phase Particles
- Effects of Size and Volume Fraction of Precipitated Crystalline Phase Induced by Friction Stir Processing on Hardness in Zr-Al-Ni-Cu Bulk Metallic Glass
- Unusual Wetting of Liquid Metals on Iron Substrate with Oxidized Surface in Reduced Atmosphere
- Oxygen Adsorption Behavior on the Surface of Liquid Cu-Ag Alloys
- Effect of Oxygen on Surface Tension of Liquid Ag-Sn Alloys
- Cavitation Behavior in Superplastically Deformed Zn-22mass% Al Alloy at Room Temperature
- Energy Absorption in Closed-Cell Al-Zn-Mg-Ca-Ti Foam
- High-Strain-Rate Superplasticity in Metallic Materials and the Potential for Ceramic Materials
- Post-characteristics of Formed Zn-22 mass%Al Alloy to Seismic Damper for General Residence
- Room Temperature Deformation Behavior of Zn-22mass%Al Alloy with Nanocrystalline Structure
- Investigation on Dynamic Friction Properties of Extruded AZ31 Magnesium Alloy Using by Ring Upsetting Method
- Creep Deformation Mechanisms in Coarse-Grained Solid Solution Mg Alloys
- The Effect of Ram Speed on Mechanical and Thermal Properties in ECAE Process Simulation
- High Cycle Fatigue Property of Extruded Non-Combustible Mg Alloy AMCa602
- High Cycle Fatigue Property and Micro Crack Propagation Behavior in Extruded AZ31 Magnesium Alloys
- Superplasticity at Room Temperature in Zn-22Al Alloy Processed by Equal-Channel-Angular Extrusion
- Pulmonary Fibrosis Associated with Polymyalgia Rheumatica
- Environmentally Friendly Composite Film of Anodizing and Electrodeposition Coating Having a High Corrosion Resistance on Magnesium Alloy AZ91D
- High Corrosion and Weather Resistant Anionic Resin Coating for 2014 T6 Aluminum Alloys Which Maintains Mirror Luster
- Optimization of Environmentally Friendly Anodic Oxide Film for Magnesium Alloys
- Elastic Constants of AlLi from First Principles
- Cold-Rolled Mg-14 mass%Li-1 mass%Al Alloy and Its Friction Stir Welding
- High-Strengthening of Mg-5.5mass%Y-4.3mass%Zn Cast Alloy by Friction Stir Processing
- Effect of Microstructural Change on High-Temperature Deformation in Pre-Annealed Zr_Al_Ni_Cu_ Bulk Metallic Glass
- Deformation Mechanism of Fine-Grained Superplasticity in Metallic Materials Expected from the Phenomenological Constitutive Equation
- Microstructure in Zn-Al Alloys after Equal-Channel-Angular Extrusion
- Materials Processing for Structural Stability in a ZK60 Magnesium Alloy
- Mechanical Properties of Mg-Y-Zn Alloy Processed by Equal-Channel-Angular Extrusion
- High-Strain-Rate Superplasticity in an AZ91 Magnesium Alloy Processed by Ingot Metallurgy Route
- Grain Size Control of Commercial Wrought Mg-Al-Zn Alloys Utilizing Dynamic Recrystallizaiton
- Effect of Grain Refinement on Tensile Ductility ZK60 Magnesium Alloy under Dynamic Loading
- Superplasticity of a Particle-Strengthened WE43 Magnesium Alloy
- Superplastic Deformation Behavior in Commercial Magnesium Alloy AZ61
- Low Temperature Superplasticity in a ZK60 Magnesium Alloy
- Processing of Ductile Magnesium Alloy under Dynamic Tensile Loading
- Improvement of Crashworthiness in Ultra Lightweight Metallic Foam by Heat-Treatment for Microstructural Modification of Base Material
- Summary in the Project "Towards Innovation in Superplasticity"
- Influence of Chlorine Forms and Dechlorination on Dioxins Formation/Suppression in the Combustion Processes (日韓資源リサイクル・材料化学に関する国際シンポジウム特集号)
- Ab Initio Calculation on the Structure and Elastic Properties of a Magnesium-Lithium Alloy
- Changes of Shape and Stress Distribution during Free Bulging in Axisymmetrically Blow-Formed Superplastic Sheet
- Novel Electroforming Process for Bulk Nanocrystalline Ni-W Alloys with Minimizing W-Concentration Gradient and Fluctuation
- Application of Electroforming Process to Bulk Amorphous Ni-W Alloy
- Effects of Flow Stress and Grain Size on the Evolution of Grain Boundary Microstructure in Superplastic 5083 Aluminum Alloy
- Ni-W Amorphous/Nanocrystalline Duplex Composite Produced by Electrodeposition
- Influence of Bath Composition on Tensile Ductility in Electrodeposited Bulk Nanocrystalline Nickel
- MALIGNANT DEGENERATION OF BENIGN CYSTIC TERATOMA OF THE BILATERAL OVARIES : ADENOSQUAMOUS CARCINOMA IN THE RIGHT TUMOUR AND SQUAMOUS CARCINOMA IN THE LEFT TUMOUR
- Effect of Titania Doping on Phase Stability of Zirconia Bioceramics in Hot Water
- Clarification of the Necessary Value of Surface Roughness for Developing Luster on an AZ31 Magnesium Alloy Surface with or without Acid Aqueous Solution Treatment
- Addition of an Aminic Antioxidant to a Hindered Ester-Based Heat Resisting Oil to Improve Lubrication for Press Forming of Magnesium Alloy Sheets
- Tribological Properties of Hybrid Process DLC Coating against Magnesium Alloy
- Optimization of Die Material and Its Surface Coating for Press Forming Magnesium Alloy
- Effect of Small Amount of Insoluble Dopant on Tetragonal to Monoclinic Phase Transformation in Tetragonal Zirconia Polycrystal
- Surface Treatment to Provide a Metallic Luster to AZ31 Magnesium Alloy
- Experimental Investigation of Cavitation Behavior in AZ61 Magnesium Alloy
- 過塩素酸水溶液中での銅(110)表面に吸着したベンゾトリアゾールのAFMその場観察
- Surface Tensions and Densities of Molten Al2O3, Ti2O3, V2O5 and Nb2O5.