Effect of Microstructural Change on High-Temperature Deformation in Pre-Annealed Zr_<65>Al_<10>Ni_<10>Cu_<15> Bulk Metallic Glass
スポンサーリンク
概要
- 論文の詳細を見る
- Japan Institute of Metalsの論文
- 2005-12-20
著者
-
TSUDA Hiroshi
Department of Materials Science, Graduate School of Engineering, Osaka Prefecture University
-
TAKIGAWA Yorinobu
Department of Materials Science, Graduate School of Engineering, Osaka Prefecture University
-
HIGASHI Kenji
Department of Materials Science, Graduate School of Engineering, Osaka Prefecture University
-
Tsuda Hiroshi
Department Of Electronics Doshisha University
-
Higashi Kenji
Department Of Materials Science Graduate School Of Engineering Osaka Prefecture University
-
KOBATA Junpei
Department of Materials Science, Graduate school of Engineering, Osaka Prefecture University
-
Higashi Kenji
Department Of Metallurgy And Materials Science College Of Engineering Osaka Prefecture University
-
Takigawa Yorinobu
Department Of Materials Science Graduate School Of Engineering Osaka Prefecture University
-
Kobata Junpei
Department Of Materials Science Graduate School Of Engineering Osaka Prefecture University
-
Higashi Kenji
Dep. Of Materials Sci. Graduate School Of Engineering Osaka Prefecture Univ.
-
Tsuda Hiroshi
Department Of Materials Science Graduate School Of Engineering Osaka Prefecture University
-
Tsuda Hiroshi
Department Of Elctronics Doshisha University
関連論文
- Catalytic Properties of Cold-Rolled Ni_3(Si, Ti) Intermetallic Foils for Methanol Decomposition
- Texture Randomization of AZ31 Magnesium Alloy Sheets for Improving the Cold Formability by a Combination of Rolling and High-Temperature Annealing
- Effect of Tool Materials on Dynamic Friction Characteristics and Microstructural Evolution at Elevated Temperature in Extruded AZ31 Magnesium Alloy
- Microstructure and Dry Sliding Wear of Ti-50Al Alloy and Ti-47Al-3W/Ti_2AlC Composite Produced by Reactive Arc-Melting
- Synthesis of TiAl(Cr)/Ti_2AIC Composites by Reactive Arc-Melting
- Microstructure and Mechanical Properties of Ti-B-N Cast Alloys Prepared by Reactive Arc-Melting
- Microstructure and Mechanical Properties of L1_2-(Al, Cr)_3Ti/Ti_2AIC Composites Prepared by Combustion Synthesis
- Microstructure and Mechanical Properties of TiAl/Ti_2AlN Composites Prepared by Combustion Synthesis
- Microstructure and Mechanical Properties of L1_2-(Al, Cr)_3 Ti/TiB_2 + Ti_2AIC Composites Produced by Reactive Arc-Melting 1
- Formation of Ternary L1_2 Intermetallic Compound and Phase Relation in the Al-Ti-Fe System
- Oxidation Resistant Coating of L1_2-(Al, Cr)_3Ti on TiAl Alloys by Pack Cementation
- Fabrication of Si3N4/SiC Composite Ceramics by Reactive Hot-Pressing from Elemental Powders (特集 ニュ-コンポジット材料)
- P1-IS-35 Clear cell carcinoma of the ovary : retrospective analysis of Japan Clear Cell Carcinoma Study
- Dissimilar Welding of Al and Mg Alloys by FSW
- Development of Constitutive Equation on Superplastic RS P/M Mg-Y-Zn Alloy
- Progression-free survival and overall survival of patients with clear cell carcinoma of the ovary treated with paclitaxel-carboplatin or irinotecan-cisplatin : retrospective analysis
- Estimation of Electron Temperatures from I-V Characteristics of a Plasma Electrode of a Negative Ion Source
- Production of Diatomic and Triatomic Molecular Negative Ions of Gold and Copper by Sputtering
- Measurement of H^- Density in a Magnetized Plasma
- Effect of Reduction Ratio of Hot-Extrusion on Microstructures of Superplastic Si_3N_4whisker/Al-Mg-Si Alloy Composites Studied by Transmission Electron Microscopy
- The Effect of Deformation Temperature on Microstructure and Superplastic Flow in Al-Cu-Mg/Si_3N_4p Composites
- Effect of Cell Size on the Dynamic Compressive Properties of Open-Celled Aluminum Foams
- The Critical Stress at the Interface for Cavity Nucleation in Superplastic Aluminum Matrix Composites Reinforced with Si_3N_4 Particles
- Development of a Closed Cell Aluminum Alloy Foam with Enhancement of the Compressive Strength
- High-Temperature Plastic Flow in Pre-Annealed Zr-Al-Ni-Cu Bulk Metallic Glass in a Supercooled Liquid Region
- Suppression of Macroscopic Defects through the Control of Friction between Workpiece and Dies in a Forged Magnesium Alloy Part with Ribs
- New Forming Process of Three-Dimensionally Shaped Magnesium Parts Utilizing High-Strain-Rate Superplasticity
- Secondary Processing of AZ31 Magnesium Alloy Concomitant with Grain Growth or Dynamic Recrystallization
- Plane-Strain Fracture Toughness on Thin AZ31 Wrought Magnesium Alloy Sheets
- The Grain Size Dependence on Diffusion Bonding Behavior in Superplastic Mg Alloys
- Experimental Study on Diffusion Bonding in Pure Magnesium
- Fracture Mechanism and Forming Limit in Deep-Drawing of Magnesium Alloy AZ31
- Effect of Small Addition of Zinc on Creep Behavior of Tin
- Effect of Pre-Introduced Shear Bands Direction on Deformation Behavior in Zr_Al_Ni_5Cu_ Bulk Metallic Glass
- Effect of Initial Grain Size on Dynamically Recrystallized Grain Size in AZ31 Magnesium Alloy
- Optimum Processing and Tool Controls for Three-Dimensional Friction Stir Welding
- Optimization of Welding Condition for Nonlinear Friction Stir Welding
- Optimization of Rolling Conditions in Mg-Al-Ca Alloy Containing Insoluble Second Phase Particles
- Effects of Size and Volume Fraction of Precipitated Crystalline Phase Induced by Friction Stir Processing on Hardness in Zr-Al-Ni-Cu Bulk Metallic Glass
- Cavitation Behavior in Superplastically Deformed Zn-22mass% Al Alloy at Room Temperature
- Energy Absorption in Closed-Cell Al-Zn-Mg-Ca-Ti Foam
- High-Strain-Rate Superplasticity in Metallic Materials and the Potential for Ceramic Materials
- Post-characteristics of Formed Zn-22 mass%Al Alloy to Seismic Damper for General Residence
- Room Temperature Deformation Behavior of Zn-22mass%Al Alloy with Nanocrystalline Structure
- HER2 Is Frequently Over-expressed in Ovarian Clear Cell Adenocarcinoma : Possible Novel Treatment Modality Using Recombinant Monoclonal Antibody against HER2, Trastuzumab
- Macrophage Colony-stimulating Factor (M-CSF) Prevents Infectious Death Induced by Chemotherapy in Mice, While Granulocyte-CSF Does Not
- Investigation on Dynamic Friction Properties of Extruded AZ31 Magnesium Alloy Using by Ring Upsetting Method
- Creep Deformation Mechanisms in Coarse-Grained Solid Solution Mg Alloys
- The Effect of Ram Speed on Mechanical and Thermal Properties in ECAE Process Simulation
- High Cycle Fatigue Property of Extruded Non-Combustible Mg Alloy AMCa602
- High Cycle Fatigue Property and Micro Crack Propagation Behavior in Extruded AZ31 Magnesium Alloys
- Superplasticity at Room Temperature in Zn-22Al Alloy Processed by Equal-Channel-Angular Extrusion
- Pulmonary Fibrosis Associated with Polymyalgia Rheumatica
- Environmentally Friendly Composite Film of Anodizing and Electrodeposition Coating Having a High Corrosion Resistance on Magnesium Alloy AZ91D
- High Corrosion and Weather Resistant Anionic Resin Coating for 2014 T6 Aluminum Alloys Which Maintains Mirror Luster
- Optimization of Environmentally Friendly Anodic Oxide Film for Magnesium Alloys
- Elastic Constants of AlLi from First Principles
- Cold-Rolled Mg-14 mass%Li-1 mass%Al Alloy and Its Friction Stir Welding
- High-Strengthening of Mg-5.5mass%Y-4.3mass%Zn Cast Alloy by Friction Stir Processing
- Effect of Microstructural Change on High-Temperature Deformation in Pre-Annealed Zr_Al_Ni_Cu_ Bulk Metallic Glass
- Deformation Mechanism of Fine-Grained Superplasticity in Metallic Materials Expected from the Phenomenological Constitutive Equation
- Microstructure in Zn-Al Alloys after Equal-Channel-Angular Extrusion
- Synthesis of TiAl-(TiB2+Ti2AlC)Composites Using Combustion Reaction Processing,Following Arc-melting (特集 金属間化合物の粉体冶金と諸物性)
- Materials Processing for Structural Stability in a ZK60 Magnesium Alloy
- Mechanical Properties of Mg-Y-Zn Alloy Processed by Equal-Channel-Angular Extrusion
- High-Strain-Rate Superplasticity in an AZ91 Magnesium Alloy Processed by Ingot Metallurgy Route
- Grain Size Control of Commercial Wrought Mg-Al-Zn Alloys Utilizing Dynamic Recrystallizaiton
- Effect of Grain Refinement on Tensile Ductility ZK60 Magnesium Alloy under Dynamic Loading
- Superplasticity of a Particle-Strengthened WE43 Magnesium Alloy
- Superplastic Deformation Behavior in Commercial Magnesium Alloy AZ61
- Low Temperature Superplasticity in a ZK60 Magnesium Alloy
- Processing of Ductile Magnesium Alloy under Dynamic Tensile Loading
- Improvement of Crashworthiness in Ultra Lightweight Metallic Foam by Heat-Treatment for Microstructural Modification of Base Material
- Epitaxial Growth of 3C-SiC on Si(111) Using Hexamethyldisilane and Tetraethylsilane
- Microstructure and Mechanical Properties of Ternary L1_2 Intermetallic Compound in Al-Ti-Cr System
- IS-15 Patients with stage IIIc ovarian clear cell carcinoma upstaged by lymph node metastasis have similar survival to other stage III clear cell carcinoma patients(Group2 Oncology2,International Session)
- Summary in the Project "Towards Innovation in Superplasticity"
- In Vitro Study of the Adsorbability of Pemphigus Antibody by a Newly Developed Immunoadsorbent, CF-X
- Ab Initio Calculation on the Structure and Elastic Properties of a Magnesium-Lithium Alloy
- Stellar Synthesis of the α-Particle Nuclei Heavier than Ne^
- Changes of Shape and Stress Distribution during Free Bulging in Axisymmetrically Blow-Formed Superplastic Sheet
- Novel Electroforming Process for Bulk Nanocrystalline Ni-W Alloys with Minimizing W-Concentration Gradient and Fluctuation
- Application of Electroforming Process to Bulk Amorphous Ni-W Alloy
- Effects of Flow Stress and Grain Size on the Evolution of Grain Boundary Microstructure in Superplastic 5083 Aluminum Alloy
- Ni-W Amorphous/Nanocrystalline Duplex Composite Produced by Electrodeposition
- Influence of Bath Composition on Tensile Ductility in Electrodeposited Bulk Nanocrystalline Nickel
- CD154 expression and mRNA stability of activated CD4-positive T cells in patients with systemic lupus erythematosus
- A case of aplastic anemia in a patient with systemic lupus erythematosus
- Correlation between Negative Hydrogen Ion Production and Work Function of Plasma Grid Surface in a Cesium-Introduced Volume-Production-Type Negative Hydrogen Ion Source
- MALIGNANT DEGENERATION OF BENIGN CYSTIC TERATOMA OF THE BILATERAL OVARIES : ADENOSQUAMOUS CARCINOMA IN THE RIGHT TUMOUR AND SQUAMOUS CARCINOMA IN THE LEFT TUMOUR
- Effect of Titania Doping on Phase Stability of Zirconia Bioceramics in Hot Water
- Clarification of the Necessary Value of Surface Roughness for Developing Luster on an AZ31 Magnesium Alloy Surface with or without Acid Aqueous Solution Treatment
- Addition of an Aminic Antioxidant to a Hindered Ester-Based Heat Resisting Oil to Improve Lubrication for Press Forming of Magnesium Alloy Sheets
- Tribological Properties of Hybrid Process DLC Coating against Magnesium Alloy
- Optimization of Die Material and Its Surface Coating for Press Forming Magnesium Alloy
- Experimental Investigation of Cavitation Behavior in AZ61 Magnesium Alloy
- Synthesis of Fe-Group Elements by the Rapid Nuclear Process
- Estrogen and urinary incontinence
- Antineutrophil cytoplasmic antibodies against myeloperoxidase, proteinase 3, elastase, cathepsin G and lactoferrin in Japanese patients with rheumatoid arthritis
- Synthesis of Iron Group Elements by the Rapid Nuclear Process