Evaluation of Resistance and Inductance of Loose Connector Contact
スポンサーリンク
概要
- 論文の詳細を見る
The contact surface of a loose connector has both contact resistance and low inductance, and the inductance depends on the distribution of the true contacts. The contact resistance and inductance were measured by time-domain reflectometry (TDR) for seven contact distribution models. The resistance was approximately constant, while the maximum inductance varied more than twofold depending on the distribution model.
著者
-
Sone Hideaki
Cyber Science Center Tohoku University
-
Mizuki Takaaki
Cyberscience Center Tohoku University
-
Hayashi Yu-ichi
Graduate School of Engineering, Tohoku University
-
UEHARA Kazuya
Graduate School of Information Sciences, Tohoku University
関連論文
- Pulse Response Characteristic of Connector Contact Failure on a Coaxial Cable
- An Analysis of EM Radiation from Transmission Line with Loose Contact of Connector
- Effect of Contact Point Distribution to the High-Frequency Impedance on a Coaxial Connector
- Computation of Electromagnetic Field Distribution in a Cross-Section of Connector with Contact Failure
- Fundamental Measurement of Electromagnetic Field Radiated from a Coaxial Transmission Line Caused by Connector Contact Failure
- The Effect of Position of a Connector Contact Failure on Electromagnetic Near-Field around a Coaxial Cable
- Effect of Inductance at Connector Contact Boundary on Common-mode Current from Interconnected Devices
- Analysis of Electromagnetic Radiation from Transmission Line with Loose Contact of Connector
- Contact Conditions in Connectors that Cause Common Mode Radiation
- Analysis of Magnetic Field Distribution around Connector with Contact Failure
- Effect of Inductance at Connector Contact Boundary on Common-mode Current from Interconnected Devices
- Evaluation of Resistance and Inductance of Loose Connector Contact