Effects of Two Stages of Electro-Magnetic Stirring on Microstructural Evolution in Rheo-Diecasting of a Near Eutectic Al–Si Alloy
スポンサーリンク
概要
- 論文の詳細を見る
A new slurry-making method consisting of two-stages of electro-magnetic(EM) stirring, was developed to manufacture high-quality slurries for rheo-diecasting of a near eutectic Al–Si based piston alloy. In the 1st stage of EM stirring, the optimized process conditions, such as the pouring temperature and the EM induction intensity were investigated to control the microstructural evolution of the primary Si particles. The 2nd stage of EM stirring was carried out to obtain fine and uniform globular α-Al particles and intermetallic compounds. High quality slurries with fine and uniform microstructures for rheo-diecasting can be obtained through the two-stages of EM stirring. Mechanical properties, such as hardness, high temperature tensile strength and relative wear resistance were evaluated on the specimens taken from the rheo-diecast products, and the results are compared with those of the conventional metal mold cast piston.
著者
-
Choi Byoung
Department Of Chemical Technology Taejon National University Of Technology Korea
-
Jang Young
Department Of Aerospace And Mechanical Engineering Rok Air Force Academy
-
Hong Chun
Department Of Metallurgical Engineering Yonsei University
-
Choi Byoung
Department of Metallurgical Engineering, Yonsei University
関連論文
- Correlation of Serial Cardiac Magnetic Resonance Imaging Parameters With Early Resolution of ST-Segment Elevation After Primary Percutaneous Coronary Intervention
- Investigation of the Substrate-Patterning Effect on Morphological Instability in Selective Area Growth
- Stochastic Modeling of Solidification Grain Structures of Al-Cu Crystalline Ribbons in Planar Flow Casting
- Latent Iron in Silicon : Semiconductors
- Adsorption of a Mixture of Thiobacillus thiooxidans and Thiobacillus ferrooxidans onto Copper-Containing Furnace Dust
- 66(P41) Two Cytotoxic Polyenes Produced from Streptomyces sp. GK9244
- Closed-loop form quantization algorithm with bounded accumulative error
- Frequency Recovery and Pulse Compression Using Brillouin-Enhanced Four-Wave Mixing in an Iodine Laser
- Purification and Characterization of Endoglucanase and Exoglucanase Components from Trichoderma viride
- Recrystallization Behavior of 7175 Al Alloy during Modified Strain-Induced Melt-Activated (SIMA) Process
- Web-Based Monitoring and Control for BAS Using Multi-Protocol Converter with Embedded Linux(Electronic Instrumentation and Control)
- Three-dimensional Simulation of Dendritic Grain Structures of Gas-atomized Al-Cu Alloy Droplets
- POD analysis on the sphere wake at a subcritical Reynolds number
- Genetic association analysis of TAP1 and TAP2 polymorphisms with aspirin exacerbated respiratory disease and its FEV1 decline
- Er3+ Photoluminescence from Er-doped Silicon-Rich Silicon Oxide Films Deposited by Laser Ablation of a Si:Er Target in an Oxygen Atmosphere
- Involvement of histaminergic system in the anxiolytic-like activities of Morus alba L. leaves in mice
- Effects of Two Stages of Electro-Magnetic Stirring on Microstructural Evolution in Rheo-Diecasting of a Near Eutectic Al–Si Alloy
- IS-2 A Study on the Building Cooling Performance of an Ice Thermal Storage System with an Evaporator in the Storage Tank