Effect of Molding Condition on the Mechanical Properties of Bamboo-Rayon Continuous Fiber/Poly(lactic acid) Composites

概要

論文の詳細を見る
Natural fiber reinforced composite materials attracts much attention from a view point of a present global environmental problem. Continuous natural fiber reinforced thermoplastic composites have superior mechanical property and have often been expected for structural materials. However, it is difficult to impregnate reinforcement fibers with thermoplastics because of high viscosity of molten plastics. In this study, continuous natural fiber reinforced thermoplastic composites were molded using intermediate materials fabricated through the micro-braiding technique. Bamboo-rayon fiber and poly(lactic acid) (PLA) fibers were used as reinforcement and matrix, respectively. Composite plates were fabricated by hot press molding under various molding conditions, including molding temperature, pressure and time. Tensile and shear tests were conducted to evaluate the effect of molding condition on mechanical properties of the composites. Tensile and shear strength increased with increasing molding temperature, whereas they are little affected by molding pressure and time. It was clarified that molding temperature of 190°C, molding pressure of 1 MPa and molding time of 4 min is optimum molding condition considering tensile strength achievement ratio.