電気防食した鋼材面の水深別付着生物の着生について
スポンサーリンク
概要
- 論文の詳細を見る
The amount of marine organisms attached to maid steel plate cathodically protected by alu-minum alloy anode, its control steel plate, and FRP (fiber reinforced plastic) plate which were immersed in 1-25m water depth, the largest attaching was found on cathodic protection plate, with the next Largest being slightly less on FRP plate and the least on the control plate On each of the three plates mentioned above, the largest amount of attaching was found ai the 3-7m depth and below the 10m depth it increased. With the cathadic protection rate, there were no noticeable changes in varied water depths. However, the corrosion rate was lower at depth of 3-7m with a higher occurence of attaching organisms, while the corrosion rate was higher at depth of 25 m. Also on the cathodic protection plate the potentials varied toward less noble, and the protective current density became lower as the amount of marine organisms increasced. Simultaneously, less noble potentials and lower current densities were observed. At 1-7m depth, where more organisms were attached than in 10-25m depth, less noble potentials in low current densities were observed.
- 日本水産學會の論文
著者
関連論文
- 防食電流密度からみた付着基盤の設置方向と付着生物着生の関係
- 電気防食鋼材面の付着生物の経時変化
- 鋼材面の防食電流密度と付着生物着生との関係について
- 金網生簧の付着生物とイシダイ類混養による除去
- 電気防食した鋼材面の水深別付着生物の着生について
- 鋼材面の防食電流密度と付着生物着生との関係について