Water-cooled target of 14 MeV neutron source Design and experiment.:Design and Experiment
スポンサーリンク
概要
- 論文の詳細を見る
A cooling system of a stationary target for the Fusion Neutronics Source (FNS) has been designed to satisfy the structural, thermal and hydraulic requirements. Two square tubes for ion beam and for cooling water were concentrically placed and the target was mounted on the top of the beam guide tube. The end plate of the outer tube was devised to be removable for easier replacement of the target. In order to test the cooling capability of the system, dummy target assemblies with electical heaters were used in the experiment of heat transfer in place of using an accelerator. Correlations of heat transfer and head loss were obtained experimentally as a function of Reynolds number. The extrapolation of the data has shown that for the present target system, about 2.3 kW is the maximum power for the beam in diameter of 15 mm. This value was sufficiently large compared with the required heat load of FNS.
- 一般社団法人 日本原子力学会の論文
著者
-
MAEKAWA Hiroshi
Japan Atomic Energy Research Institute
-
Sanokawa Konomo
Japan Atomic Energy Research Institute
-
Seki Masahiro
Japan Atomic Energy Research Institute
-
Ogawa Masuro
Japan Atomic Energy Reseach Institute
-
KAWAMURA Hiroshi
Japan Atomic Energy Research Institute
関連論文
- Radiation Effect of YBa_2Cu_3O_ Irradiated by γ-Rays and 14 MeV Neutrons : Electrical Properties of Condensed Matter
- Heat Transfer between Metallic Surfaces in Contact : 1st report, The Conditions of Both Metals in Contact Being the Same
- Performance Test Results of Mock-up Test Facility of HTTR Hydrogen Production System
- Heat Transfer between Metallic Surfaces in Contact : 2nd Report, The Effects of the Thickness of metal, and the Conditions of Both Metals in Contact Being Different
- Heat Transfer between Metallic Surfaces in Contact : 4th Report, The Effects of the Shape of Surface Roughness and the Waviness, and the Approximate Method of Calculating Thermal Contact Resistance
- National Circulation in Parallel Vertical Channels with Different Heat Inputs
- Effects of Entrance Configuration on Pressure Loss and Heat Transfer of Transitional Gas Flow in a Circular Tube : Fluids Engineering, Heat Transfer, Combustion, Power, Thermophysical Properties,
- Heat Transfer between Metallic Surfaces in Contact : 3rd Report, The Effect of Oxidation of Contacting Surfaces
- Mass Transfer of Mixed Gas Flow Crossing A High Temperature Graphite Cylinder with Chemical Reactions and In-Pore Diffusion
- Monte Carlo calculations of source characteristics of FNS water cooled type tritium target.
- Hydraulics of coolant flow through control rod channel in very high temperature gas cooled reactor.
- Development of thin film thermometer and its application to radiation loss measurement in JFT-2 tokamak.
- Preliminary thermal cycling test of tungsten-copper duplex structure for use as divertor plate.
- Effect of nonelastic neutron anisotropy on fission rates measured in a graphite-reflected lithium assembly.
- Experiments and calculations of 14MeV neutron streaming through multi-layered slit assembly.
- Evaluation on differences of fuel centerline temperatures of high performance fuel rods irradiated in JMTR.
- Water-cooled target of 14 MeV neutron source Design and experiment.:Design and Experiment
- Incipient boiling of sodium in presence of magnetic field.
- Absolute fission-rate distribution in graphite-reflected lithium oxide blanket assembly.