Performance Test Results of Mock-up Test Facility of HTTR Hydrogen Production System
スポンサーリンク
概要
- 論文の詳細を見る
For the purpose to demonstrate effectiveness of high-temperature nuclear heat utilization, Japan Atomic Energy Research Institute has been developing a hydrogen production system and has planned to connect the hydrogen production system to High Temperature Engineering Test Reactor (HTTR). Prior to construction of a HTTR hydrogen production system, a mock-up test facility was constructed to investigate transient behavior of the hydrogen production system and to establish system controllability. The Mock-up test facility with a full-scale reaction tube is an approximately 1/30-scale model of the HTTR hydrogen production system and an electric heater is used as a heat source instead of a reactor. After its construction, a performance test of the test facility was carried out in the same pressure and temperature conditions as those of the HTTR hydrogen production system to investigate its performance such as hydrogen production ability, controllability and so on. It was confirmed that hydrogen was stably produced with a hot helium gas about 120 m3/h, which satisfy the design value, and thermal disturbance of helium gas during the start-up could be mitigated within the design value by using a steam generator. The mock-up test of the HTTR hydrogen production system using this facility will continue until 2004.
- 社団法人 日本原子力学会の論文
- 2004-03-25
著者
-
OHASHI Hirofumi
Japan Atomic Energy Agency
-
NISHIHARA Tetsuo
Japan Atomic Energy Agency
-
SHIOZAWA Shusaku
Japan Atomic Energy Agency
-
TAKADA SHOJI
Japan Atomic Energy Research Institute
-
INAGAKI Yoshiyuki
Japan Atomic Energy Agency
-
Shiozawa Shusaku
Japan Atomic Energy Research Institute
-
Katanishi Shoji
Japan Atomic Energy Research Institute
-
INABA Yoshitomo
Japan Atomic Energy Research Institute
-
TAKEDA Tetsuaki
Japan Atomic Energy Research Institute
-
HAYASHI Koji
Japan Atomic Energy Research Institute
-
OGAWA Masuro
Japan Atomic Energy Research Institute
-
Inaba Yoshitomo
Japan Atomic Energy Agency
-
Ogawa Masuro
Japan Atomic Energy Reseach Institute
-
TAKEDA Tetsuaki
Japan Atomic Energy Agency
関連論文
- Analysis of Tritium Behavior in Very High Temperature Gas-Cooled Reactor Coupled with Thermochemical Iodine-Sulfur Process for Hydrogen Production
- Interpolation and Extrapolation Method to Analyze Irradiation-Induced Dimensional Change Data of Graphite for Design of Core Components in Very High Temperature Reactor (VHTR)
- Improvement of Analysis Technology for High Temperature Gas-Cooled Reactor by Using Data Obtained in High Temperature Engineering Test Reactor
- ICONE11-36369 A VERIFICATION PLAN OF ROTOR DYNAMICS OF TURBOMACHINE SYSTEM SUPPORTED BY AMB FOR THE GTHTR300 (STEP 1)
- Development Scenario of the Iodine-Sulphur Hydrogen Production Process to be Coupled with VHTR System as a Conventional Chemical Plant
- Numerical Study on Tritium Behavior by Using Isotope Exchange Reactions in Thermochemical Water-Splitting Iodine-Sulfur Process
- ICONE11-36368 THE 1/3-SCALE AERODYNAMICS PERFORMANCE TEST OF HELIUM COMPRESSOR FOR GTHTR300 TURBO MACHINE OF JAERI (STEP 1)
- ICONE11-36319 A Conceptional Design Study on the Hydrogen Production Plant Coupled With the HTTR
- ICONE11-36371 Design and development of Gas Turbine High Temperature Reactor 300
- Performance Test Results of Mock-up Test Facility of HTTR Hydrogen Production System
- ICONE11-36059 PERFORMANCE TEST RESULTS OF MOCK-UP TEST FACILITY OF HTTR HYDROGEN PRODUCTION SYSTEM
- ICONE11-36370 SAFETY DESIGN PHILOSOPHY OF GAS TURBINE HIGH TEMPERATURE REACTOR (GTHTR300)
- ICONE11-36272 The Study for the Core and Reactor Structure Configuration for GTHTR-300
- National Circulation in Parallel Vertical Channels with Different Heat Inputs
- Importance Determination Method for Geometry Splitting with Russian Roulette in Monte Carlo Calculations of Thick and Complicated Core Shielding Structure
- Effects of Entrance Configuration on Pressure Loss and Heat Transfer of Transitional Gas Flow in a Circular Tube : Fluids Engineering, Heat Transfer, Combustion, Power, Thermophysical Properties,
- Pellet-Cladding Mechanical Interaction of PWR Fuel Rod Under Rapid Power Transient
- Mass Transfer of Mixed Gas Flow Crossing A High Temperature Graphite Cylinder with Chemical Reactions and In-Pore Diffusion
- Numerical Analysis on Air Ingress Behavior in GTHTR300-Cogeneration System
- Hydraulics of coolant flow through control rod channel in very high temperature gas cooled reactor.
- Fundamental Study on Thermo-Hydraulic Phenomena Concerning Passive Safety of Advanced Marine Reactor.
- Cladding embrittlement and fuel rod failure threshold under reactivity initiated accident condition.
- Preliminary thermal cycling test of tungsten-copper duplex structure for use as divertor plate.
- Water-cooled target of 14 MeV neutron source Design and experiment.:Design and Experiment
- Incipient boiling of sodium in presence of magnetic field.